Instruction Manual: Light Kit for Hoth AT-ST 75322

Thank You

For purchasing this product. To achieve the perfect hidden-line effect, we use severely thin aviation-grade wire with high tension and pressure tolerance. However, due to its thin nature, be careful not to cut through it as it might be susceptible to shearing during installation. Always be careful not to press brick pieces down on the wire.

Let's Get Started

If you face any challenges, please feel free to reach out via support@gameofbricks.eu. Please note that we offer 2 years of free light kit maintenance.

Step 1 (Bag 1)

A bag labeled "1" containing thin wires and red LED components is shown. The AT-ST model is partially assembled.

Hands are shown attaching red LEDs to the lower leg sections of the AT-ST model.

Hands continue attaching red LEDs to the AT-ST's leg assemblies, routing the thin wires.

More red LEDs are being connected to the leg components.

Hands are shown inserting the red LED assemblies into the AT-ST's leg structure.

The red LEDs are integrated into the AT-ST's legs.

Step 2 (Bag 2)

A bag labeled "2" is shown containing thin wires and small white LED strips. The AT-ST model is being worked on.

Hands are connecting white LED strips to the main body and head sections of the AT-ST.

Hands are shown routing wires for the white LEDs within the AT-ST's head assembly.

White LEDs are being attached to the AT-ST's head components.

Further installation of white LEDs into the AT-ST's body, with wires carefully managed.

White LEDs are being placed into specific connection points on the AT-ST.

Hands are shown connecting more white LED strips to the AT-ST's chassis.

The white LEDs are being integrated into the AT-ST's leg and body structure.

Final placement of white LEDs into the AT-ST's design.

Wires are being routed neatly for the white LEDs.

Step 3 (Bag 3)

A bag labeled "3" is shown containing a single white LED component.

Hands are attaching this white LED to the top of the AT-ST's head.

Step 4 (Bag 4)

A bag labeled "4" is shown containing a USB power cable and additional LED components.

Hands are connecting the power cable and LED components to the AT-ST's main body.

Wires are being connected and routed within the AT-ST's internal structure.

The USB power cable is being connected to the main board or distribution point.

The final connections are being made, showing the illuminated AT-ST.

A view of the fully assembled and illuminated Hoth AT-ST model.

Final Connection

Connect the light kit to the battery box, and installation will be complete. If you wish to use another power source, please ensure the maximum voltage does not exceed 6V.