Game of Bricks Light Kit for LEGO Star Wars Clone Commander Cody Helmet 75350
Game of Bricks
Instruction Manual
Thank You
Thank you for purchasing this product. To achieve the perfect hidden-line effect, we use severely thin aviation-grade wire with high tension and pressure tolerance. However, due to its thin nature, be careful not to cut through it as it might be susceptible to shearing during installation. Always be careful not to press brick pieces down on the wire.
Let's Get Started
If you face any challenges, please feel free to reach out via support@gameofbricks.eu. Please note that we offer 2 years of free light kit maintenance.
Installation Steps
Step 1 (Bag 1)
Begin by preparing the components from Bag 1. This bag contains thin wires with small LED components attached at intervals, and a main wire.
Carefully place a thin wire with LEDs along the top edge of the helmet's visor area, positioning the LEDs between the LEGO bricks.
Guide the wire around the side of the helmet's faceplate.
Tuck the wire into place, ensuring it is secure and not pinched.
The LEDs should now illuminate the visor area.
Step 2 (Bag 2)
Prepare the components from Bag 2.
Insert a wire with an LED into a specific LEGO brick connection point on the side of the helmet.
Connect additional wires to designated points on the helmet's structure.
Route the wires through the helmet's internal structure, ensuring they are neatly organized.
Tuck the wires into place.
Step 3 (Bag 3)
Prepare the components from Bag 3, which contains multiple wires with LEDs.
Route the wires from the front of the helmet towards the back.
Guide the wires down the back of the helmet, preparing them for connection to the power source.
Connect the wires to the base or internal structure of the helmet as indicated.
Step 4 (Bag 4)
Prepare the components from Bag 4, which includes wires and a USB connector.
Connect the prepared wires with LEDs to the base of the helmet.
Attach the USB connector to the main wire harness.
Route the USB connector and associated wires neatly.
The helmet should now be wired, ready for final connection.
Step 5 (Bag 5)
Prepare the components from Bag 5, which includes wires and a USB connector.
Attach a small LED component to a specific location on the helmet.
Route and connect the wires as shown.
Connect the USB connector to the main wire harness.
Connect the wires to the base of the helmet.
The base of the helmet should now have the wires connected, leading to the USB power source.
The final assembled helmet with lights should be complete.
Final Connection
Connect the light kit to the battery box, and the installation will be complete. If you wish to use another power source, please ensure the maximum voltage is 6V.
