Instruction Manual

Important Information

Please read instructions carefully. Be sure you have all parts before you begin to assemble.

Assemble furniture on a clean, flat surface such as carpet to avoid scratching.

Attention:

• To ensure easy assembly, we advise all fittings be finger tightened during the initial assembly.
• Once the product is assembled, all fittings should be fully tightened.
• We recommend a periodic check on all fixing points to make sure they remain fully tightened.
• Do not tighten the screws before all screws are in place.

This package contains small parts and sharp points; keep away from children and babies until assembly is complete.

Max safe load limit: 8.4KG for total.

Assembly Steps

1. Attach two 'D' pieces to one 'E' piece using screws 'I'.

   [Diagram showing two D panels attached vertically to the base E panel with screws I]

2. Attach another 'E' piece to the top of the 'D' pieces using screws 'I'.

   [Diagram showing the second E panel being attached to the top of the D panels with screws I]

3. Attach 'F' and 'G' pieces to the structure using screws 'I'.

   [Diagram showing F and G panels being attached to the partially assembled unit with screws I]

4. Continue assembling the internal dividers ('D' pieces) using screws 'I'.

   [Diagram showing more D panels being added as internal dividers, secured with screws I]

5. Attach the remaining 'D' pieces to the sides of the unit using screws 'I'.

   [Diagram showing the side D panels being attached to the main structure with screws I]

6. Attach side panels 'B' and 'C' to the assembled structure using screws 'I'.

   [Diagram showing side panels B and C being attached to the unit with screws I]

7. Attach the top panels 'A' to the unit using screws 'I'.

   [Diagram showing the two top panels A being attached to the unit with screws I]

8. Wall Mounting Instructions:

   Note: There are two installation methods available.

   (1) Using the two outer mounting points or (2) using the two inner mounting points.

   Secure the unit to the wall using the provided 'H' fittings (wall plugs and screws).

   [Diagram illustrating wall mounting with H fittings, showing two options for mounting points]