XTRFY MZ1 WIRELESS QUICK-START GUIDE
Getting Started
Follow these steps to set up your Xtrfy MZ1 Wireless mouse.
-
Connect the USB receiver to your computer.
Illustration shows a USB receiver being plugged into a port.
-
Connect the charging cable to the mouse and a power source.
Illustration shows the USB cable and receiver components separated, ready for connection.
-
Use the switch on the bottom of the mouse to turn it ON.
Illustration shows a switch with options: OFF, CPI, RGB, PGDN, and ON. The switch is shown in the ON position.
Battery Status and RGB
The mouse indicates battery status and RGB mode through LED indicators.
- Battery Level Indicators:
- ⚡ (Full), ⚡ (Medium), ⚡ (Low)
- RGB Indicator: Shows the current RGB lighting mode.
Battery Level Chart:
- • 0-25%
- • 26-50%
- • 51-75%
- • 76-100%
Illustration shows battery level icons and a color-coded chart for battery percentage.
Customization Options
The MZ1 Wireless mouse offers various customization options accessible via the switch and buttons.
DPI Settings
Cycle through DPI levels using the designated button/switch position.
- CPI: 400 (Red), 800 (Orange), 1200 (Yellow), 1600 (Green), 3200 (Blue), 4000 (Purple), 7200 (Cyan), 19000 (White)
Illustration shows the mouse with the CPI setting highlighted, and a list of CPI values with corresponding colors.
Polling Rate
Adjust the polling rate for optimal performance.
- Polling Rate: 125 Hz (Red), 500 Hz (Blue), 1000 Hz (Green)
Illustration shows the mouse with the polling rate setting highlighted, and a list of polling rates with corresponding colors.
RGB Effects and Color
Customize your RGB lighting.
- Cycle through various RGB effects.
- Select your preferred color for the RGB lighting.
Illustrations show the mouse with RGB effects and color selection options highlighted.
Brightness and Speed
Adjust the brightness of the RGB lighting and the speed of effects.
- Brightness: ?+ / ?-
- Speed: ⏩+ / ⏪-
Illustrations show controls for adjusting brightness and speed.
Advanced Settings
Lift-Off Distance
Set the lift-off distance for the mouse sensor.
- 1 MM •
- 2 MM •
Illustration shows the mouse with lift-off distance settings highlighted.
Debounce
Adjust the debounce time for button clicks.
- 2 MS •
- 4 MS •
- 8 MS •
- 12 MS •
Illustration shows the mouse with debounce time settings highlighted.
Maintenance and Reset
Factory Reset
To reset the mouse to factory settings, press and hold the designated button for 5 seconds.
Illustration shows the mouse with the factory reset button highlighted.
Weight Balance
The MZ1 Wireless mouse is designed for optimal weight balance. Adjustments can be made by adding or removing internal components if applicable.
Illustration shows the bottom of the mouse with weight balance adjustment points, and a diagram indicating a 1mm adjustment.
Remove Shell
Instructions for removing the mouse shell for internal access or customization.
Illustrations show the process of removing the mouse shell, including screw locations.
Important Information
⚠️ CHARGE THE MOUSE VIA COMPUTER USB PORT ONLY
For the full manual, scan the QR code below or go to XTRFY.COM/DOWNLOADS.
For support, contact SUPPORT@XTRFY.COM.
Xtrfy
