CLAGE E-mini Instant Water Heater M/SNM
Product Information
Application Areas
Single point supply:
- Washbasin
- Sanitary facilities in commercial buildings
Product Specifications
| Feature | M3/SNM | M3(E)/SNM |
|---|---|---|
| Part number | 1500-17203 | 1500-172032 |
| Type | open-outlet | open-outlet |
| Water connections (thread connections) | G³/8" | G³/8" |
| Hot water output at Δt = 25 K [l/min] | 2.0 | 2.0 |
| Switch-on flow rate / max. flow rate [l/min] | 1.3 / 2.0 | 1.3 / 2.0 |
| Nominal power rating [kW] | 3.5 | 3.5 |
| Supply voltage [1~ / N / PE 230 V AC] | With plug | Permanent connection |
| Nominal current [A] | 15 | 15 |
| Required cable diameter [mm²] | 1.5 | 1.5 |
| Bare wire heating system IES® | ✔ | ✔ |
| VDE approved / Protection class | / IP 25 | / IP 25 |
| Specific water resistance at 15 °C [cm] ≥ | 1100 | 1100 |
| Nominal volume [litres] | 0.2 | 0.2 |
| Weight filled with water [kg] | approx. 1.5 | approx. 1.5 |
| Dimensions (height × width × depth) [cm] | 13.5 x 18.6 x 8.7 | 13.5 x 18.6 x 8.7 |
¹ Temperature increase e.g. from 15°C to 40°C. ² Limited flow amount for optimal temperature increase. Can be adjusted via water amount adjustment.
Description
- Hydraulically controlled instant water heater (undersink model) with compact design for the energy-efficient hot water supply of a washbasin with vented two-handle mixer tap and spout and eyelet chain.
- The full heating capacity turns on automatically as soon as water flows through the unit.
- Efficient flow technology for an optimum water jet and economical water consumption.
- The efficient bare wire heating system IES® with replaceable heating cartridge provides an extended service life and easy maintenance.
- Ready to use, vented design.
- Set is easy to install with flexible steel hoses G½ inch x 50 cm and power cable 60 cm.
- Aerator insert for the tap is included.
Profitability Comparison
Saves up to 85% energy compared to conventional small storage heaters.
The E-compact instant water heater features economical operation. The water is heated directly as it flows through the unit. Hot water is not stored in a tank, which saves standby energy that would be otherwise required.
Diagram description: A comparison showing energy savings. A conventional 5-litre storage heater is shown on the left, and a CLAGE E-mini instant water heater is shown on the right. An arrow indicates that the E-mini saves up to 85% energy.
Installation
Sample installation (open-outlet)
Assembly and operating instructions must be observed upon installation.
Diagram description: A diagram illustrating the sample installation of the E-mini instant water heater under a washbasin. It shows the water connections, power cable, unit dimensions, and recommended placement relative to the washbasin and angle valve. Key measurements are provided in millimeters. The aerator is shown in use with the tap.
- Using the aerator (included)
- (shorten cable if necessary)
- Unit depth 87
- Power plug approx. 700
- Cable inlet approx. 553
- Fastener approx. 520
- Angle valve outlet G½"
- Washbasin top edge approx. 850 – 950
Accessories
Aerator CSP 3 (included)
The aerator at the tap supports the energy- and water-saving operation of the compact instant water heater. The new special CSP aerators mix air into the water and thus create a uniform water stream that does not splatter but softly cascades down.
Aerator insert for tap adapter M22/24 at the tap
CSP 3 (< 2 l/min): Part no. 0010-00421
Contact Information
CLAGE GmbH
Pirolweg 1-5
21337 Lüneburg
Germany
Phone: +49 4131 8901-38
Fax: +49 4131 2444771
Email: export@clage.de
Website: www.clage.com
