Brookstone Flip Spin 360° RC Stunt Vehicle
Instruction Booklet
Key Features:
- [Light Effects] Virtuosic Light Effects
- [USB] Quick Charge
- [25 min Battery Life] 25 Minutes Battery Life
- [2.4 GHz Control System] Strong 2.4 GHz Control System
- [R/C Range: 65 ft / 20 m] R/C Range: Up to 65 ft / 20 m
- [360 Degree Flips & Stunts] 360 Degree Flips & Stunts
- [Front End Flips, 360° Two Sided Stunts] Front End Flips, 360° Two Sided Stunts
- [Racing Beats] Racing Beats
Safety Information & Compliance
FCC Part 15 Notice Statement:
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:
- (1) This device may not cause harmful interference, and
- (2) This device must accept any interference received, including interference that may cause undesired operation.
Warnings:
- Adult supervision required.
- Do not attempt to modify the remote control in any way.
- All packaging material must be removed by an adult.
Cautions:
- Do not mix old and new batteries.
- The supply terminals are not to be short-circuited.
- Non-rechargeable batteries are not to be charged.
- Always remove weak or used or dead batteries from the product.
- Do not dispose of batteries in fire; batteries may explode or leak.
- Rechargeable batteries are to be removed from the toy before being charged.
- Rechargeable batteries are only to be charged under adult supervision.
- Only batteries of the same or equivalent type as recommended are to be used.
- Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
- The toy must be fully assembled in accordance with the instructions before operating.
- Be sure to insert the batteries correctly and always follow the toy and battery manufacturers' instructions.
Important Notice: Do not use this RC vehicle in inclement weather. Both vehicle and remote are not waterproof.
Operation
Charging the Car Battery
Follow these steps to charge the vehicle's battery:
- Make sure the RC Car is in the OFF position.
- Use a screwdriver to remove the underside battery compartment door and remove the battery pack.
- Insert the charging cable into the battery pack connector.
- Plug the [USB Symbol] cable into a computer's USB port or a USB wall charger. A red light indicator should appear while charging.
- Approximate charging time is ~2.5 hours. Play time will last approximately 20-25 minutes on a full charge.
- Reconnect the Battery Pack to the Car and Close the Battery Door with a screwdriver.
Charging Diagram Description:
- Step 1: "Open Battery Box with Phillips-Head Screwdriver". Illustrates unscrewing the battery compartment door.
- Step 2: "Disconnect Battery Pack Carefully". Illustrates lifting the battery pack out of its compartment.
- Step 3: "Note the Orientation of the Prongs". Shows the battery pack connector with its prongs.
- Step 4: "Connect Battery Pack to USB Charging Cable to Charge". Shows the battery pack connector plugged into a USB cable, which is then connected to a [USB Power Adapter] or computer.
Package Contents:
- 1x Flip Spin 360 RC Car
- 1x Controller
- 1x USB Charging Cable
- 1x 3.7V Rechargeable Battery
- 2x [1.5V AA Battery] Batteries (included)
- 1x Quick Start Manual
RC Car & Remote Control Functions:
Remote Control Layout:
- Left/Right Turn: Controlled by a joystick.
- Forward/Backward: Controlled by another joystick.
- Power Indicator: A light on the remote.
RC Car Power:
- The RC Car has an "ON" / "OFF" power switch located on its underside.
Remote Control Battery Installation:
Back View of Remote:
- Unscrew the battery compartment cover to open.
- Lift the tab to open the battery door.
- Insert 2 new [1.5V AA Battery] alkaline batteries (included) into the compartment.
- Close the battery door.
Syncing the Remote Control with Your Brookstone® RC Vehicle
This vehicle uses 2.4GHz remote control technology, allowing up to 8 different vehicles to be synced to their own remote controls without wireless interference.
To Connect One RC Vehicle:
- Ensure both the Vehicle and Remote Control switches are in the "OFF" position. Make sure no other 2.4GHz devices are active nearby.
- Switch the Vehicle to the "ON" position (switch is located on the underside).
- Turn on your Remote Control to the "ON" position. The remote control light should blink until it automatically connects to the vehicle.
To Connect Multiple 2.4GHz RC Vehicles:
- Ensure all Vehicles and Remote Controls are in the "OFF" position. Verify no other 2.4GHz devices are in the area. Note: Each vehicle must be synced one at a time to avoid wireless interference.
- Follow steps 1-3 above for each car, one at a time.
After a vehicle has been synced, leave the Vehicle and Remote Control in the "ON" position until all players are synced. Repeat the above steps if interference between vehicles occurs.
[1 Year Warranty] Warranty Details
BROOKSTONE Toys provides a 1-year warranty from the purchase date, as indicated on the purchase receipt. This warranty is supplementary to the statutory warranty rights in the state of purchase.
The warranty covers the function of the product. It does not include external damages due to normal wear, accident-related damage, misuse, or negligence. The warranty does not apply in the event of failure to observe the operation or assembly instructions. Any battery pack included in the delivery is explicitly excluded from the warranty. The validity of the warranty expires in case of improper use or tampering.
Scope and Application of the Warranty
All claims arising during the warranty period should be communicated in writing as per instructions below. Claims for lost products are excluded.
To enforce a warranty claim, please return any problematic items still under warranty, along with the original purchase receipt, to:
BROOKSTONE Toys
132 West 36th Street, RM 800
New York, NY 10018
Please retain the original purchase receipt together with the warranty conditions for the duration of the warranty period. BROOKSTONE Toys reserves the right to refuse a warranty repair or confirmation if proof cannot be provided.
Please ensure the product is safely packed for transport. BROOKSTONE Toys is not responsible for damage during transport or damages incurred when returning the product.
Manufacturer & Distributor Information
Manufactured, marketed, and distributed by INNOVATIVE DESIGNS, LLC under license.
INNOVATIVE DESIGNS, LLC
132 W. 36TH ST., RM 800
NEW YORK, NY 10018
Item Numbers: 706483BRS, F11604/21L706483
© 2021 ALL RIGHTS RESERVED. BROOKSTONE® TRADEMARKS, NAMES AND LOGOS ARE OWNED BY BKST BRAND HOLDINGS, LLC.