Unitek DiskGuard Limpid R SATA III 2.5" HDD/SSD Enclosure

Product Overview

The Unitek DiskGuard Limpid R is a 2.5-inch hard disk enclosure designed for SATA III HDD and SSD drives. Its transparent design allows for easy identification of the installed drive.

Package Contents

The package typically includes:

• 1 x DiskGuard Limpid R Enclosure
• 1 x USB 3.0 Cable
• 1 x User Manual
• 1 x Screw Set
• 1 x Foam Pad

Installation Guide

Follow these steps to install your HDD/SSD:

1. Open the enclosure by sliding the back cover.
2. Insert your 2.5-inch SATA HDD or SSD into the enclosure, aligning the connectors.
3. Gently push the drive until it is securely seated.
4. Slide the back cover back into place until it clicks.
5. Secure the enclosure with the provided screws using a screwdriver.
6. Attach the foam pad to the bottom of the enclosure for stability.

Connecting the Enclosure

Connect the enclosure to your computer using the provided USB 3.0 cable. Plug the other end into a USB port on your computer.

Note: For optimal performance, connect the cable to a USB 3.0 port (usually blue).

System Requirements

The enclosure is compatible with most operating systems, including:

• Windows
• macOS
• Linux

A USB port is required for connection.

Troubleshooting

Drive not recognized:

• Ensure the drive is properly seated in the enclosure.
• Try a different USB port on your computer.
• Verify the USB cable is securely connected at both ends.
• Check if the drive is formatted and functional on another computer.

Slow transfer speeds:

• Confirm the enclosure and computer are connected via USB 3.0.
• Ensure the drive itself is not the bottleneck.

Specifications

• Model: S1103A
• Interface: USB 3.0 to SATA III
• Supported Drive Size: 2.5-inch HDD/SSD
• Supported Capacity: Up to 6TB (check drive compatibility)
• Data Transfer Rate: Up to 5Gbps (USB 3.0)
• Material: ABS Plastic
• Dimensions: [Specify dimensions if available]
• Color: Transparent

Safety Precautions

• Avoid exposing the enclosure to extreme temperatures or moisture.
• Handle the drive and enclosure with care to prevent damage.
• Disconnect the USB cable before removing the drive.