UNITEK Y-3032 Dual Bay Hard Drive Docking Station

Product Overview

The UNITEK Y-3032 is a Dual Bay Hard Drive Docking Station that supports SATA 2.5"/3.5" hard drives. It offers SuperSpeed 5Gbps data transfer rates and includes an offline clone function.

Package Contents

• Dual Bay Hard Drive Docking Station
• USB Data Cable (USB-A to USB-B, 120cm)
• 12V/3A Power Adapter
• User Manual

Safety Notes

• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.
• Do not open the device or continue to operate it if it becomes damaged.
• Do not modify the product in any way. Doing so voids the warranty.
• Do not operate the product outside the power limits given in the specifications.
• Protect the product from dirt, moisture and overheating, and only use it in a dry environment.
• Do not use the product in moist environments and avoid splashes.
• Do not drop the product and do not expose it to any major shocks.
• Keep this product, like all electrical products, out of the reach of children!

UNITEK assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Warranty Disclaimer

UNITEK assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.

Technical Data

• Hard Drive Version: SATA (Serial ATA) 2.5"/3.5”
• Input Voltage: 100-240V 50/60 Hz
• Power Adapter Output Voltage/Current/Power: 12V DC / 3A / 36W

Product Diagram and Indicators

Front:

• A: Green LED Indicator: Light on when power is connected; Light on 1s after 3s when Auto Sleep mode is on.
• B: Yellow LED Indicator: Light flashes during Disk A reading/writing.
• C: Blue LED Indicators: 4 indicators referring to cloning progress from 25%, 50%, 75% to 100%.
• D: Yellow LED Indicator: Light flashes during Disk B reading/writing.
• E: Clone Button
• F: Disk A slot
• G: Disk B slot

Back:

• H: USB-B Interface
• I: DC 12V Power Port
• J: On/Off Switch

How to Clone

1. Press and hold the Clone Button (E) for 3 seconds until the blue indicator is on, then release and press it again. The clone process from Disk A to Disk B will begin. Ensure that the storage capacity of Disk B is equal to or larger than Disk A.
2. The four blue lights (C) will illuminate sequentially (25%, 50%, 75%, 100%) to indicate cloning progress. The clone is complete when all blue indicators are lit.
3. Turn off the docking station and unplug the power supply before safely ejecting Disk A or Disk B.

Notice: If the blue indicator keeps flashing, your disk might have bad sectors. Bad sectors will be ignored during cloning to help complete the process, unless they cause the disk to malfunction. It is recommended to seek expert advice for disk repair.

System Compatibility

• Compatibility: USB-A Port
• USB Specification: USB 3.2 Gen 1
• Systems Supported (PC, Laptop & Tablet): Windows XP or later, Mac OS X or later, Linux

Service and Support

For further support information, please visit: www.unitek-products.com

Email: support@unitek-products.com