FIAMMA RAFTER LED

Product Overview and Specifications

The Fiamma Rafter LED is a lighting system designed for recreational vehicles, providing illumination for awnings. It is not suitable for domestic environments.

Technical Specifications:

• Type: LED COB
• Beam Angle: 120°
• Luminous Flux: 1228 Lm
• Color Temperature: 4000 k
• Lifespan: 30000 h
• Voltage: 12Vdc
• Power Consumption: 13 W
• Current: 1.25 A
• Ingress Protection: IP65
• Color Rendering Index: CRI > 90
• Weight: 1.4 kg

Certifications:

UK CA, CE, F

Installation Instructions

Important: Installation should be carried out by qualified personnel in compliance with current local regulations. Always check that all parts are undamaged before installation.

1. Step 1: Preparation

   Diagram Description (1A/1B): Shows the Rafter LED being prepared for insertion into the awning rail. The diagram indicates "MAX" for the insertion limit on both F45 and F80 awning types.

2. Step 2: Insertion

   Diagram Description (2): Illustrates the Rafter LED (Part A) being slid into the awning rail. An arrow indicates the direction of insertion.

3. Step 3: Securing the LED Strip

   Diagram Description (3): Shows a close-up of a locking mechanism. A rotating element is depicted, indicating how to secure the LED strip within the rail.

   Diagram Description (F45/F80 detail): Provides a closer view of the Rafter LED fitting into the specific rail types (F45 and F80), showing the engagement of the securing mechanism.

4. Step 4: Final Check

   Diagram Description (4): Depicts the Rafter LED fully installed and seated in the awning rail. The detail view shows the end of the LED strip properly fitted.

5. Step 5: Repeat Securing

   Diagram Description (5): This step reiterates the securing process shown in Step 3, emphasizing the locking mechanism.

6. Step 6: Power Connection

   Diagram Description (6): Shows the power cable (Part B) with a 12V cigarette lighter plug. The cable is connected to the vehicle's 12V power outlet. The diagram indicates the cable length is approximately 5 meters.

   Note: Connect the power cable to the vehicle's cigarette lighter. Damage to the power cable can lead to abnormal operation.

Safety and Usage Precautions

We remind you that the awning is a sun protection, so please close your awning in case of ?️, ?, or ?️. Otherwise, please take the following precautions: lower one side of your awning, so that water can flow away and place the Rafter.

⚠️ ATTENTION: We only suggest a temporary use of the tension Rafter.

Driving Warning: It is strictly forbidden to drive with the LED lights on. Ensure the power supply is connected in a way that inhibits current flow while the vehicle is in motion.

Viewing Caution: Avoid prolonged viewing of the LED strip at close proximity.

General Safety: Failure to observe installation and usage instructions, as well as local driving laws, may cause severe harm or damage. The manufacturer is not responsible for damages resulting from defective installation, connection, mechanical influences, overvoltage, or unauthorized alterations.

Warranty Information

In case of defects regarding materials and manufacturing, the customer is entitled to warranty in accordance with local laws and regulations of the country where the product was purchased.

Declaration of Conformity

Fiamma S.p.A. declares that the Rafter LED and related lighting systems conform to relevant Union harmonisation legislation, including directives such as EMCD, LVD, RoHS, and standards like EN 60529 and IEC 62471.

Manufacturer: Fiamma S.p.A.

Address: Via San Rocco, 56, 21010 Cardano al Campo (Varese), Italy.

Contact: fiamma@fiamma.it