Casio Analog Watch Operation Guide

Notes

Some water resistant models are equipped with a screw lock crown. With such models, you must unscrew the crown in the direction noted in the illustration to loosen it before you can pull it out. Do not pull too forcibly on such crowns. Also note that such watches are not water resistant while their crowns are loosened. Be sure to screw the crowns back in as far as they will go after making any setting.

[Modules 5284, 5361, and 5364]

To set the time

1. When the second hand is at 12 o'clock, pull out the crown to stop it.
2. Set the hands by rotating the crown. Move the minute hand four or five minutes past the setting you want, and then back them up to the setting.
3. Push the crown back in on a time signal to resume timekeeping.

The crown is indicated by an arrow pointing to it, with text 'Crown' next to it. A circular arrow indicates the direction of rotation.

To set the time

1. When the second hand is at 12 o'clock, pull out the crown to the second click to stop it.
2. Set the hands by rotating the crown. Move the minute hand four or five minutes past the setting you want, and then back them up to the setting.
3. Push the crown back in on a time signal to resume timekeeping.

To set the day

Avoid setting the day between 9:00 p.m. and 1:00 a.m. The day may not change in the following day if you do.

1. Pull out the crown to the first click.
2. Set the day by rotating the crown.
3. Push the crown back in to its normal position.

[Modules 5125, 5167, 5223, 5237, 5249, and 5339]

To set the time

1. When the second hand is at 12 o'clock, pull out the crown to the second click to stop it.
2. Set the hands by rotating the crown. Move the minute hand four or five minutes past the setting you want, and then back them up to the setting.
3. Push the crown back in on a time signal to resume timekeeping.

To set the day and day of the week

Avoid setting the day and day of the week between 9:00 p.m. and 5:00 a.m. The day and day of the week may not change in the following day if you do.

1. Pull out the crown to the first click.
2. Set the day by rotating the crown counterclockwise.
3. Set the day of the week by rotating the crown clockwise.
4. Push the crown back in to its normal position.

For watches with an elapsed time bezel: Rotate the elapsed time bezel to align the triangle mark (▲) with the minute hand. After a certain amount of time has elapsed, read the graduation on the elapsed time bezel that the minute hand points to. The elapsed time is indicated.

The elapsed time bezel is shown with markings from 0 to 60, with the minute hand pointing to a specific time.

Specifications

[Module 5364] Low Battery Indicator: Second hand moves in 2-second increments when power is low.