SJE VERTICALMASTER® PUMP SWITCH

The SJE VerticalMaster® mechanically-activated pump switch is designed for direct control of pumps up to 1/2 HP at 120 VAC and 1 HP at 230 VAC for:

• Non-potable water applications
• Sewage applications
• Limited space applications

It works well in small sump chambers, effluent applications, and laundry trays, as well as in large tanks.

The SJE VerticalMaster® pump switch is not sensitive to turbulence. It is available for pump down applications only.

FEATURES

• Heavy-duty contacts
• Controls pumps up to 1/2 HP at 120 VAC and 1 HP at 230 VAC
• Adjustable pumping range of .75 to 6.5 inches (2 to 17 cm)

PUMP DOWN / ON POSITION

Diagram shows contacts closed with yoke.

PUMP DOWN / OFF POSITION

Diagram shows contacts open with yoke.

OPTIONS

This switch is available:

• with a 120 VAC or 230 VAC piggy-back plug
• without a plug for direct wiring in 120 VAC or 230 VAC applications
• in standard cable lengths of 10, 15, 20, or 30 feet and 3, 5, 6, or 10 meters (longer lengths available)

UL Recognized for Water & Sewage

SJE RHOMBUS.

*This item is an SJE Rhombus Quick Ship product which normally ships within 1 business day from receipt of order at no additional charge.

1 = 120VAC, 2 = 230VAC, WP = With Plug, WOP = With Out Plug

NOTE: Descriptions are grouped by cable length measured in feet (10, 15, 20, 30).

MOUNTING BRACKET and HOSE CLAMP are standard.

PACKAGING: Boxed - Standard

ADDITIONAL CABLE: Longer cable lengths available.

SPECIFICATIONS

PUMPING RANGE: 0.75 to 6.5 inches (2 cm to 17 cm)

CABLE: flexible 16 gauge, 2 conductor (UL, CSA) SJOW or SJTOW, water-resistant (CPE).

MOUNTING BRACKET AND CLAMP: stainless steel

LIFT ROD: injection molded acetal plastic

FLOAT STOP: neoprene

SWITCH AND FLOAT HOUSING: high impact, corrosion resistant, PVC housing for use in sewage and non-potable water up to 125°F (52°C)

Overall dimensions: 12 inch high x 5 inch x 3 inch wide (30.5 cm x 12.7 cm x 7.6 cm)

Switch housing dimensions: 2 inch high x 2.8 inch diameter (5 cm x 7.1 cm)

Float housing dimensions: 2.3 inch high x 2.8 inch diameter (5.8 cm x 6.9 cm)

ELECTRICAL:

NOTE: This switch must be used with pumps that provide integral thermal overload protection.

A Pump Switch is designed for Horsepower (HP) rated loads and is not suitable for control (pilot duty) applications. It will fail prematurely when switching loads less than 1 Amp at 120 VAC. Select a float switch from our Control Switch offering for control applications.

OTHER INFORMATION

PUMP DOWN is normally open contacts for emptying.

DIRECT WIRING: Units used for direct wiring (without plug) may be used in either 120 VAC or 230 VAC applications within specified amp ratings.

California Prop 65 requires the following: WARNING Cancer and Reproductive Harm - www.P65Warnings.ca.gov

For more information, visit www.sjerhombus.com or email: customer.service@sjeinc.com. Call Toll Free 888-342-5753.