Shark NV392 Navigator Lift-Away Owner's Guide

Important Safety Instructions

FOR HOUSEHOLD USE ONLY PLEASE READ CAREFULLY BEFORE USE

If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT force into outlet or try to modify to fit.

⚠️ WARNING

To reduce the risk of fire, electric shock, injury, or property damage:

General Warnings

• Your vacuum cleaner may consist of a motorized nozzle, wand, hose, and/or vacuum pod. This device contains electrical connections, electrical wiring, and moving parts that potentially present risk to the user.
• Use only identical replacement parts.
• Carefully observe and follow the instructions provided below to avoid improper use of the appliance. DO NOT use the vacuum for any purpose other than those described in this manual.
• Before use, carefully inspect all parts for any damage. DO NOT use if any parts are damaged.
• The use of an extension cord is NOT recommended.
• This vacuum cleaner contains no serviceable parts.

Use Warnings

• DO NOT allow the appliance to be used by children. Close supervision is necessary when used near children. This is not a toy.
• Always turn off the vacuum cleaner before connecting or disconnecting any motorized nozzles or other accessories.
• DO NOT handle plug or vacuum cleaner with wet hands.
• DO NOT use without filters in place.
• Only use Shark® branded filters and accessories. Failure to do so will also void the warranty.
• DO NOT damage the power cord:
  • DO NOT pull or carry vacuum cleaner by the cord or use the cord as a handle.
  • DO NOT unplug by pulling on cord. Grasp the plug, not the cord.
  • DO NOT run the vacuum cleaner over the power cord, close a door on the cord, pull the cord around sharp corners, or leave the cord near heated surfaces.
• DO NOT put any objects into nozzle or accessory openings. DO NOT use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce airflow.
• DO NOT use if nozzle or accessory airflow is restricted. If the air paths or the motorized floor nozzle become blocked, turn the vacuum cleaner off and unplug from electrical outlet. Remove all obstructions before you plug in and turn on the unit again.
• Keep nozzle and all vacuum openings away from hair, face, fingers, uncovered feet, or loose clothing.
• DO NOT use if vacuum cleaner is not working as it should, or has been dropped, damaged, left outdoors, or dropped into water.
• Use extra care when cleaning on stairs.
• DO NOT leave the vacuum cleaner unattended while plugged in.
• When powered on, keep the vacuum cleaner moving over the carpet surface at all times to avoid damaging the carpet fibers.
• DO NOT place vacuum cleaner on unstable surfaces such as chairs or tables.
• Your Shark® vacuum may not be designed to stand up on its own. When taking a break from cleaning, you may need to lean it against furniture or a wall, or lay it flat on the floor. Using the vacuum for an application where the unit lacks stability may result in personal injury.
• DO NOT use to pick up:
  • Liquids
  • Large objects
  • Hard or sharp objects (glass, nails, screws, or coins)
  • Large quantities of dust (drywall dust, fireplace ash, or embers). DO NOT use as an attachment to power tools for dust collection.
  • Smoking or burning objects (hot coals, cigarette butts, or matches)
  • Flammable or combustible materials (lighter fluid, gasoline, or kerosene)
  • Toxic materials (chlorine bleach, ammonia, or drain cleaner)
• DO NOT use in the following areas:
  • Poorly lit areas
  • Wet or damp surfaces
  • Outdoor areas
  • Spaces that are enclosed and may contain explosive or toxic fumes or vapors (lighter fluid, gasoline, kerosene, paint, paint thinners, mothproofing substances, or flammable dust)
• Turn off all controls before plugging in or unplugging the vacuum.
• Unplug from electrical outlet when not in use and before any maintenance or cleaning.
• Hand wash with water only. Washing with cleaning chemicals could damage the unit.
• During cleaning or routine maintenance, DO NOT cut anything other than hair, fibers, or string wrapped around the brushroll.
• Allow all filters to air-dry completely before replacing in the vacuum to prevent liquid from being drawn into electric parts.
• Make sure the dust cup and all filters are in place after routine maintenance.
• If provided, secure the power cord around the two cord hooks during storage.

To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

Assembly

Follow these steps to assemble your Shark Navigator Lift-Away vacuum cleaner. Ensure all parts are firmly clicked into place for proper operation.

1. Place the Pod onto the Floor Nozzle Post.
2. Insert the Wand into the pod.
3. Attach the Accessory Holder onto the wand and store accessories on it.
4. Insert the Handle into the top of the wand.
5. Connect the Hose to the back of the pod.

Whole-Home Cleaning

Settings

Power/Surface Switch

Select surface setting:

• O Power Off
• I Bare Floor: For bare floors and small area rugs.
• II Carpet: For high pile carpets.

Suction Control

Suction Control offers variable suction based on your needs. Slide to MIN to reduce suction and increase maneuverability on carpets. Slide to MAX to increase suction on bare floors.

Brushroll Indicator Light

Indicator Light Meaning:

• Solid Green: The brushroll is spinning and working as it should.
• Solid Red: There is a jam in the brushroll area. Turn your vacuum off and remove any blockages in the nozzle.
• Flashing Red: The motorized floor nozzle is overheating. Turn your vacuum off and wait a minimum of 45 minutes for it to cool down.

For deep carpet cleaning per ASTM F 608, set to MAX suction and Carpet.

Cleaning Modes

Upright Mode

To engage Brushroll, place foot on floor nozzle and tilt handle back.

Above-Floor-Handle Mode

Press the Handle Release button to detach the handle from the wand.

Above-Floor-Wand Mode

Press the Wand Release button to detach the wand from the pod.

Lift-Away® Mode

Press the Lift-Away button to detach the pod from the floor nozzle.

With pod removed, press the Wand Release button to detach the wand from the pod.

All accessories attach to either the wand or the handle.

Maintenance

Emptying the Dust Cup

IMPORTANT: Unplug the power cord before performing any maintenance.

1. To remove Dust Cup, lift tabs on both sides of dust cup handle. Tilt dust cup forward, then lift to remove.
2. Press lower release button to open bottom of dust cup.
3. To remove collected debris from Lint Screen, press top release button and lift handle to open. Gently brush lint screen to clean.
4. To reinstall, place bottom of dust cup into pod and then tilt back until it clicks into place.

Cleaning and Replacing the Filters

Regularly clean and replace the Filters to keep your vacuum's suction power optimal.

To clean filters, rinse with cold water only to prevent damage from cleaning chemicals. Allow all filters to air-dry for at least 24 hours before reinstalling them to prevent liquid from being drawn into electric parts.

IMPORTANT: DO NOT use soap when cleaning the filters.

Pre-Motor Filters (Foam & Felt)

Clean EVERY 3 MONTHS:

• Remove dust cup, then lift out filters.

HEPA Filter

Clean EVERY YEAR:

• Press button at bottom of Filter Door. Tilt filter door and lift it out. Remove HEPA Filter.
• To reinstall, insert HEPA filter into unit and replace the filter door.

Checking for Blockages

Follow these steps to check for and clear blockages in your vacuum cleaner.

• Detach hose from vacuum pod, and check hose and opening on back of pod for blockages.
• Detach wand from floor nozzle and handle, and check both ends for blockages.
• Detach wand from floor nozzle, tilt nozzle neck back, and check opening for blockages.
• Detach handle from wand and hose from the vacuum pod, and check openings for blockages.
• Detach dust cup from vacuum pod. Empty dust cup, remove debris from lint screen, and check for blockages.

Maintenance

Cleaning the Brushroll

Using a coin, turn locks counterclockwise, then open the door to access brushroll. ? NOTE: Door hinges open but is not completely removable.

Debris Wrapped Around Brushroll

Clean off any debris on the brushroll.

Available Accessories

• A Crevice Tool: Gives you extended cleaning reach for small spaces.
• B Wide Upholstery Tool: Wide cleaning path helps remove pet hair, dust, and large debris from mattresses, couches, curtains, lampshades, and other delicate upholstered surfaces.
• C Dusting Brush: Dust shelves, lampshades, window blinds, furniture, and other upholstered household items.
• D Pet Power Brush: Designed to remove pet hair and ground-in dirt from carpeted stairs and upholstery.
• E Multi-Angle Dusting Brush: Offers 5 different positions for cleaning shelves, blinds, walls, ceiling fans, and more. Adjust the angle of the brush to the desired cleaning surface.
• F Dust-Away® Hard Floor Attachment: Durable enough to vacuum up big crumbs but gentle enough to wipe away fine dust on hardwood and tile floors with the washable and reusable microfiber pad. Its swivel motion allows easy access to hard-to-reach areas.

NOTE: Not all accessories come with all units. Please see the enclosed Quick Start Guide for your unit's configuration. To order additional accessories, visit sharkaccessories.com.

Troubleshooting

Vacuum is not picking up debris. No suction or light suction.

• Check filters to see if they need cleaning. Follow instructions for rinsing and air-drying the filters before reinserting in the vacuum.
• Dust cup may be full; empty dust cup.
• Check hose, hose connections, nozzle, wand, pod, and accessories for blockages. Clear any blockages found. Refer to Checking for Blockages section for more information.

Vacuum lifts area rugs.

• Make sure Power/Surface switch is set to Hard Floor (setting I).
• Suction is powerful. Take care when vacuuming area rugs or rugs with delicately sewn edges.
• To minimize suction, slide suction control collar to MIN.

Brushroll does not spin.

• If the Brushroll Indicator Light turns red, immediately turn off and unplug the vacuum. Remove pod from floor nozzle and clear any blockages. Reconnect nozzle, plug in vacuum, and turn on power.
• With the power on, recline the handle, which will automatically turn on the brushroll.
• Ensure that the Power/Surface switch is set to Carpet (position II) for brushroll to spin.

Vacuum turns off on its own or indicator light flashes red.

This vacuum is equipped with a motor-protective thermostat. If your vacuum overheats, the thermostat will automatically turn the suction motor off. Perform the following steps to restart the thermostat:

1. Turn vacuum off and unplug it.
2. Empty dust cup and clean filters. See Emptying the Dust Cup and Cleaning Filters.
3. Check for blockages in hose, accessories, and inlet openings.
4. Allow unit to cool for a minimum of 45 minutes.
5. Plug in vacuum and turn it on.

Five (5) Year Limited Warranty

The Five (5) Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable.

SharkNinja warrants that the unit shall be free from defects in material and workmanship for a period of five (5) years from the date of purchase when it is used under normal household conditions and maintained according to the requirements outlined in the Owner's Guide, subject to the following conditions and exclusions:

What is covered by this warranty?

• The original unit and/or non-wearable components deemed defective, in SharkNinja's sole discretion, will be repaired or replaced up to five (5) years from the original purchase date.
• In the event a replacement unit is issued, the warranty coverage ends six (6) months following the receipt date of the replacement unit or the remainder of the existing warranty, whichever is later. SharkNinja reserves the right to replace the unit with one of equal or greater value.

What is not covered by this warranty?

• Normal wear and tear of wearable parts (such as foam filters, HEPA filters, pads, etc.), which require regular maintenance and/or replacement to ensure the proper functioning of your unit, are not covered by this warranty. Replacement parts are available for purchase at sharkaccessories.com.
• Any unit that has been tampered with or used for commercial purposes.
• Damage caused by misuse (e.g., vacuuming up water or other liquids), abuse, negligent handling, failure to perform required maintenance (e.g., not cleaning the filters), or damage due to mishandling in transit.
• Consequential and incidental damages.
• Defects caused by repair persons not authorized by Shark Ninja. These defects include damages caused in the process of shipping, altering, or repairing the SharkNinja product (or any of its parts) when the repair is performed by a repair person not authorized by SharkNinja.
• Products purchased, used, or operated outside North America.

How to get service

If your appliance fails to operate properly while in use under normal household conditions within the warranty period, visit sharkclean.com/support for product care and maintenance self-help. Our Customer Service Specialists are also available at 1-800-798-7398 to assist with product support and warranty service options, including the possibility of upgrading to our VIP warranty service options for select product categories.

SharkNinja will cover the cost for the customer to send in the unit to us for repair or replacement. A fee of $24.95 (subject to change) will be charged when SharkNinja ships the repaired or replacement unit.

How to initiate a warranty claim

You must call 1-800-798-7398 to initiate a warranty claim. You will need the receipt as proof of purchase. A Customer Service Specialist will provide you with return and packing instruction information.

How state law applies

This warranty gives you specific legal rights, and you also may have other rights that vary from state to state. Some states do not permit the exclusion or limitation of incidental or consequential damages, so the above may not apply to you.

Register Your Purchase

• Visit registeryourshark.com
• Scan QR code using mobile device

Benefits of registering your product and creating an account:

• Get easier, faster product support and access to warranty information
• Access troubleshooting and product care instructions
• Be among the first to know about exclusive product promotions

TIP: You can find the model and serial numbers on the QR code label on the bottom of the back of the vacuum pod.

Record This Information

Model Number: _________________________

Serial Number: _________________________

Date of Purchase: _________________________ (Keep receipt)

Store of Purchase: _________________________

Technical Specifications

• Voltage: 120V, 60Hz
• Watts: 805W
• Amps: 6.7A

Contact Information & Copyright

SharkNinja Operating LLC

US: Needham, MA 02494

CAN: Ville St-Laurent, QC H4S 1A7

Phone: 1-800-798-7398

Website: sharkclean.com

For SharkNinja U.S. Patent information, visit sharkninja.com/uspatents

© 2019 SharkNinja Operating LLC. DUST-AWAY, LIFT-AWAY, SHARK, and SHARK NAVIGATOR are registered trademarks of SharkNinja Operating LLC. NAVIGATOR is a trademark of SharkNinja Operating LLC.

Model Number: NV392_IB_REV_Mv7

Printed in China