Tommee Tippee Travel Bottle and Food Warmer

Parts Guide

The travel bottle warmer consists of the following parts:

• A. Insulated Flask
• B. Screw cap and pourer
• C. Open/close button
• D. Beaker
• E. Silicone seal

Using the Travel Bottle Warmer

Follow these steps to prepare and use the warmer:

1. Unscrew and lift off the beaker.
2. Unscrew the screw cap and inspect the silicone seal to ensure it is securely in place and intact to prevent leakage.
3. Pour a maximum of 500ml of freshly boiled water into the insulated flask.
4. Replace the screw cap and twist until secure.
5. To open the pourer, press the button in the centre of the screw cap down.
6. Place the bottle or food jar into the beaker.
7. Pour water from the insulated flask into the beaker. Ensure the water level does not rise above the neck of the bottle. To close the pourer, press the button again. It is closed when the lid is flush.

Heating and Usage:

1. Heat the milk or food to the desired temperature.
2. Take care when removing the bottle or jar, as it and the surrounding water will be hot.
3. Always check the food temperature before feeding your baby.

Cleaning Instructions

Insulated Flask

• The container should be cleaned periodically. For best results, use a mixture of water and bicarbonate of soda or washing up liquid. Rinse thoroughly afterwards.
• Never use in a dishwasher.

Beaker

• Wash in warm soapy water and rinse in clean water, or use a dishwasher. Do not clean with solvents or harsh chemicals.

Important Warnings

• Do not use to store or carry carbonated drinks.
• To minimise bacterial growth, do not use to keep warm milk products or baby food.
• Pre-heat or pre-cool the container with water to ensure efficient use. Never use microwave or conventional ovens for this purpose.
• ⚠️ Caution: The flask can contain boiling water, posing a potential scalding hazard. Ensure lids are securely fastened. Open with care. Keep out of reach of children.
• Always use on a flat, heat-resistant surface.
• Always place the bottle or food jar into the beaker before adding water.
• Empty the beaker immediately after use.
• Children should be supervised to ensure they do not play with this appliance. Always keep out of the reach of children.
• When the feed has reached the desired temperature, remove it immediately. If left in the warmer, the temperature of the feed will continue to increase.