Ecler GROUNDY Installation Quick Guide

Installation Steps

1. Step 1: Install the wire connection

   Connect the wire as shown in the diagram. A circular connector with a red center is depicted, alongside scissors indicating cutting or preparation.

   Diagram shows a vertical pole with points labeled A and B, and blue arrows indicating wire path. The wire is shown entering from the top and exiting at point A.

2. Step 2: Fix the support at the desired depth

   Insert the support into the ground to the required depth. Red arrows indicate downward force for insertion.

   Diagram shows a square post being inserted into a cubic representation of the ground. A wire is shown emerging from the ground and entering the post.

3. Step 3: Fix the adaptor with the clip

   Attach the adapter using the provided clip. Two types of fixings are specified: M5 for eMOTUS3 and M6 for eMOTUS5 NIMBO-14.

   Diagram shows two adapter components being joined. One component has a clip mechanism. Another diagram shows a screw (M5) and a nut for eMOTUS3, and a screw (M6) for eMOTUS5 NIMBO-14. Blue arrows indicate the direction of attachment.

4. Step 4: Fix the wall bracket the adaptor (wall brackets included with the speaker)

   Secure the wall bracket to the adapter. The diagram shows screws (M6x45mm included) being used to attach the bracket to the adapter assembly.

   Diagram shows a bracket assembly with a pivoting arm, being attached to the top of a pole. Screws are shown being inserted. The text specifies this is for eMOTUS3 & eMOTUS5 and NIMBO-14 models.

For technical queries, contact your supplier, distributor, or complete the contact form on the Ecler website under Support/Technical requests.

Ecler Motors, 166-168 - 08038 Barcelona - Spain. Tel. (+34) 932238400 | information@ecler.com | www.ecler.com