POWERTECH

Box Contents:

• Lamp
• Solar Panel
• Remote Controller
• Support Bracket
• Wall Bolts
• Operating Manual

Installation:

1. Take out the lamp from the packaging.
2. Press the power button [power-symbol] on the remote controller.
3. The light should turn on automatically.

Once the waterproof connector is connected correctly, place the Solar Panel towards the sunlight. The light should automatically turn off and the charging indicator (located on the lamp unit) will flash regularly. This indicates that the solar panel is charging the batteries correctly. The connector has alignment arrows to ensure correct connection.

Fix the product on the wall using the supplied wall bolts. The suggested installation height is between 3-6 meters.

A diagram shows a wall bracket with two mounting points. Another diagram illustrates the solar panel mounted above the lamp, tilted slightly.

Please ensure the Solar panels are installed at the correct angle for your country and hemisphere. The sunlight reaching the panel should not be blocked by obstacles such as trees, shadows, or buildings. Unobstructed sunlight is necessary for correct charging.

Diagrams illustrate solar panel angles and charging efficiency:

• 35° angle (south): 100% charging efficiency ✔️
• 10° angle (south): 75% charging efficiency ❌
• 60° angle (south): 50% charging efficiency ❌

Tips:

1. Install the solar panel facing 5-10 degrees south to west, with an angle of 35 degrees relative to the horizontal.
2. Ensure the panel is affixed firmly to a permanent structure to prevent movement due to wind.
3. Use the supplied remote to select the desired brightness and duration for the light. Note: Some keys on the remote may be reserved for other models.

Remote Controller Instructions:

The remote control features a power button [power-symbol] (press before use), ON/OFF buttons, brightness adjustment (+/-), timer settings (3H, 12H), Warm White (WW) selection, and RGB color controls (Red, Green, Blue, RGB breathing mode).

The document also shows smartphone app interface screenshots illustrating Bluetooth connection steps: clicking the Bluetooth button, scanning the device, and connecting/disconnecting.

App:

Scan the QR code to download the companion app. (QR code excluded from this document).

App Usage Steps:

1. Power on the lamp (press the red button).
2. Click the Bluetooth button in the app.
3. Scan for the device.
4. Connect or disconnect the device.

The app provides operating instructions and allows control over lighting modes.

Connect Bluetooth Speaker: (Optional)

Connecting a Bluetooth speaker is optional and allows compatibility with app functions such as lighting modes and music rhythm synchronization.

Remote Controller Functions:

Detailed breakdown of remote control buttons:

• Power Button [power-symbol]: Press before use.
• ON/OFF: Controls the power state of the light.
• + / - : Adjusts brightness.
• 3H / 12H: Sets a 3-hour or 12-hour timer.
• WW: Selects warm white light.
• RGB: Cycles through RGB colors and modes, including a breathing effect.
• RED, GREEN, BLUE: Selects specific solid colors.

Distribution Information:

Distributed by: Electus Distribution Pty Ltd

Address: 46 Eastern Creek Dr, Eastern Creek NSW 2766 Australia

Phone: 1300 738 555

International Phone: +61 2 8832 3200

Fax: 1300 738 500

Website: www.electusdistribution.com.au