Neomounts FL15-650WH1 Tablet Floor Stand

Parts List

Assembly Instructions

Step 1: Attach Adhesive Pads

Attach the adhesive pads (J) to the bottom of the base (A).

Step 2: Route Cable and Attach Pole

Route the cable through the pole (B) and attach the pole to the base (A). Use the cable clip (I) and M8x20 screws (N) for this step.

Step 3: Install Mount to Floor

Step 3A: Wooden Floor Installation

Install the mount on a wooden floor. Drill holes of approximately Ø4.5mm (Ø3/16"). Secure the base (A) to the floor using appropriate screws (not explicitly listed, but implied for floor mounting).

Step 3B: Concrete/Brick Floor Installation

Install the mount on a concrete or solid brick floor. Drill holes of approximately Ø10mm (Ø3/8"). Use wall anchors (O) and screws (not explicitly listed, but implied) for secure mounting. Cover the screw heads with screw covers (P).

Step 4: Attach Holder to Pole

Attach the holder base (D) to the pole (B) using M5x6 screws (M). Unlock the holder mechanism as shown in the diagram. The general Allen key (Q) may be used here.

Step 5: Install Tablet Holder

Remove the clamp cover (G) from the holder arm (E). Place the tablet in the holder. Attach the tablet clamp plate (F) to the holder arm (E) with 4 M4x12 screws (L). Adjust the two clamps for solid placement and correct alignment of the tablet before fully tightening the screws (H).

Tablet Compatibility Guide:

• Panel 1: For 9.7" iPad 5/6, iPad Air 1/2 & iPad Pro (Gen 1)
• Panel 2: For 10.2" iPad 7/8/9 & 10.5" iPad Air 3, iPad Pro (Gen 2)
• Panel 3: For 11" iPad Pro (Gen 3/4/5) & 10.9" iPad 10, iPad Air 4
• Panel 4: For 10.4" Samsung Galaxy Tab A7
• Panel 5: For 10.1" Samsung Galaxy Tab A
• Panel 6: For 10.4" Samsung Galaxy Tab S6 Lite

Note: Remove foam parts before installation.

Step 6: Adjust Torque

Adjust the torque using the 4mm Allen key (R) or 5mm Allen key (S). This controls the tension and movement of the holder's joints.

Step 7: Adjust Mount Position

Adjust the mount to the desired viewing position.