Poly Edge E300 Series Quick Start

Contents

• Wall Mount Brackets
• Ethernet Network Cable (0.18m / 7in)
• 1 x M3 x 8mm T10 screw
• 4 x M3 x 8mm screws

Management Software

Poly Lens

Manage your devices at: poly.com/lens

Tools for Wall Mount

Tools required for wall mounting: a power drill and a screwdriver.

Ordered Separately

• Poly Edge E300 Series Handset
• Handset Cord
• Ethernet Network Cable (1.5m / 5ft)
• AC Power Adapter (Optional)

Required Cabling and Mounting

Step 1: Connect the Ethernet cable and handset cord to the rear ports of the Poly Edge E300 Series phone. The diagram highlights the Ethernet port (labeled 'E') and the handset port (labeled 'H').

Step 2: Route the connected cables through the cable management channel on the back of the phone. The diagram shows the cables being guided into a groove.

Step 3: Slide the wall mount bracket onto the back of the phone until it clicks into place. The diagram shows a grey mounting bracket being attached to the phone's rear.

Step 4: Separate the wall mount assembly into two components: the main mounting plate and the cable cover. The diagram illustrates these two parts being disassembled.

Step 5: Mount the main wall mount plate to the desired wall surface using three M3 x 8mm screws (not included). The diagram shows the plate being secured to a wall with screws.

Step 6: Attach the cable cover to the mounted plate. The diagram shows the grey cable cover being fitted onto the main plate, with arrows indicating the direction of attachment.

Step 7: Connect the Ethernet cable and handset cord to their respective ports on the wall-mounted bracket assembly. The diagram shows the cables plugging into the bracket.

Step 8: Connect the AC power adapter (if used) to the phone and a power outlet. The diagram shows the phone connected to the wall mount and powered.

Optional Cabling and Mounting

An optional mounting configuration is shown, illustrating alternative attachment methods or cable management for the phone to the wall mount bracket.