Sprout Coat Cubby Assembly Instructions

Product Overview

This document provides step-by-step instructions for assembling the Sprout Coat Cubby. It is designed for ease of use and clear guidance.

Important Notes:

• Adult assembly is required.
• Assemble completely before use.
• Two people are recommended for assembly.

Parts Included

• A: Left Side
• B: Right Side
• C: (4) Vertical Dividers
• D: Bottom
• E: Toe
• F: Top Shelf
• G: Seat
• H: Top
• I: Back
• J: (10) Long Screws
• K: (10) Pegs
• L: (14) Washers
• M: (4) Short Screws

Before You Start

Tab Orientation: Orient tabs so the side with the wider lip faces the same direction as the notch in the slot. [Diagram showing tab orientation]

Inserting Tabs: Place tabs into open slots then lock them into the notches. Ensure tabs are fully locked, and edges should be flush. [Diagram showing tab locking]

Assistance: A rubber mallet can help push pieces together. A hammer can also be used with a protective layer (like scrap wood or a cutting board) over the surface being hammered to prevent damage.

Assembly Instructions

1. Step 1: Install Pegs

   Insert Pegs (K) into the Back (I). Use a Long Screw (J) and Washer (L) for each peg, threading the screw through the diagonal holes (marked 'HOLES GOING DOWN+RIGHT' and 'HOLES GOING DOWN+LEFT' in diagrams) and then onto the peg. Ensure pegs are on the front side and in the correct holes.

2. Step 2: Attach Toe

   Place the Toe (E) into the slots on the Bottom (D) and push to tighten.

3. Step 3: Attach Seat

   With assistance, place the Seat (G) into the slots of the Vertical Dividers (C), inserting two dividers at a time. Ensure the Seat's circular groove faces the bottom of the unit.

4. Step 4: Attach Top Shelf

   Place the Top Shelf (F) into the slots of the Vertical Dividers (C). Ensure the Top Shelf's groove faces the bottom of the unit. Tighten by pushing down on the Top Shelf and Seat (G).

5. Step 5: Connect Top Shelf and Seat to Side

   Insert and lock the tabs of the Top Shelf (F) and Seat (G) into the slots of the Right Side (B).

6. Step 6: Position for Further Assembly

   With assistance, carefully tilt the assembly onto the face of the Right Side (B).

7. Step 7: Attach Top, Bottom, and Dividers to Side

   Insert tabs on the Top (H) and Bottom (D) into the slots on the Right Side (B). Lock the tabs of the Vertical Dividers (C) into the slots on the Top (H) and Bottom (D).

8. Step 8: Attach Back Panel

   Place the tabs on the Back (I) into the slots on the Right Side (B), Top (H), and Bottom (D). Assistance is recommended to steady the assembly. Ensure the side of the Back panel with pegs is facing the unit.

9. Step 9: Attach Left Side

   Place the Left Side (A) onto the exposed tabs. Carefully tilt the assembly onto the Back (I).

10. Step 10: Secure Left Side

    Lock the tabs on the Left Side (A). Verify that all other tabs are locked and edges are flush. Carefully tilt the unit upright onto its feet.

11. Step 11: Finalize Back Panel

    Finish installing the Back (I) by inserting Short Screws (M) straight through the designated holes, using Washers (L). Screw until tight.

Important Safety Information

Please be aware that improperly installed screws can risk splitting the wood and may pose a safety hazard to children.

Support

STOP Frustrated? Need Help?

Talk to our customer service agent at: +1 (833) 530-0033