Euhomy Portable Nugget Ice Maker

Congratulations

Dear Customer:

Welcome to the Euhomy family. Thank you for purchasing one of our products.

Our goal is to provide you with superior service. If there is anything missing from or wrong with your order, or if you have any questions about using our ice maker, PLEASE contact us.

Email: support@euhomy.com

Facebook: @Euhomy.Official

The Euhomy team is available 24/7 to address your questions, comments, and concerns. Your satisfaction is our ultimate goal. We want to make everything right so you'll share your positive experience with other shoppers on Amazon.

If you experience any problems, please send an email to support@euhomy.com.

Our mission:

• To be the most trusted appliance brand.
• To create practical, compact appliances that better your life.

Be sure to register at www.euhomy.com/register for updates, warranty, and other relevant information.

Safety Instructions

Your safety, as well as the safety of others, is of utmost importance to us.

• We have incorporated many important safety messages in the manual of your appliance.
• Always read and follow all the safety instructions.
• Below is the safety alert symbol: !
• All Safety messages will follow the safety alert symbol and the word "DANGER" or "WARNING".

These words mean:

DANGER: Death or severe injury will occur if you don't follow the instructions properly.

All safety messages provide information on potential hazards, ways to reduce the risk of injury, and consequences of not following the instructions.

Preparing Your Ice Maker for Use

Safety Tips

When using electric appliances, it's vital to follow basic safety steps to lower the risk of fires, electric shocks, or harm to people and property. Make sure to read all the instructions before you start using any appliance.

• Do not use this product or any other appliance if the cord is damaged.
• If the power cord is damaged, replace it with a new one from the manufacturer, their service agent, or an expert to avoid potential risk.
• Make sure you place this ice-maker in a location where the plug is easily accessible. It is important to only connect it to properly grounded outlets, and avoid plugging anything else into the same outlet.
• Double-check that the plug is fully inserted into the socket. Ensure that the power cord is not running over carpeting or other heat insulators.
• Do not cover the cord. Keep the cord out of traffic areas, and away from water.
• It is not recommended to use an extension cord as it can cause overheating and potentially lead to a fire. However, if it is absolutely necessary to use one, make sure it's rated at least 14AWG and can handle a minimum of 1875 watts.
• Remember to unplug the ice maker before performing any cleaning, repairs or service.
• Be cautious and vigilant when children are present near this appliance.
• Don't use your ice maker outside. Set it up in a location that is away from direct sunlight and make sure there is a gap of at least a 6-inch between the back of your unit and the wall. Also, keep a minimum distance of 6 inches free on each side of your unit to ensure proper ventilation.
• Do not use any other liquid. Only use water to make the ice-cube.
• Do not use flammable fluids to clean your ice maker as the fumes may cause a fire or explosion.
• Please make sure to keep the ice maker steady and avoid causing it to fall over.
• If the ice maker is brought in from outside in wintertime, give it a few hours to warm up to room temperature before plugging it in.

WARNING: This appliance must be grounded.

DANGER: Risk Of Fire or Explosion. Flammable Refrigerant Used. Do Not Use Mechanical Devices To Defrost Ice Maker. Do Not Puncture Refrigerant Tubing. To Be Repaired Only By Trained Service Personnel.

CAUTION: Consult Repair Manual/Owner's Guide Before Attempting To Install or Service This Product. All Safety Precautions Must be Followed. Dispose Of Property In Accordance With Federal Or Local Regulations. Flammable Refrigerant Used. Follow Handling Instructions Carefully. Flammable Refrigerant Used.

The ice maker must be installed in accordance with the safety standard of Refrigeration Systems, ASHRAE15. Do not install the ice maker in public building corridors or hallways.

If the unit is malfunctioning and requires maintenance, it should be serviced by factory authorized personnel. Replacement of any components should be done with similar parts to minimize the risk of ignition caused by incorrect parts or improper service.

Attention:

The wires in this power cord are colored based on the following code:

• Green or Green with a strip yellow: Grounding
• White: Neutral
• Black: Live

To avoid a hazard due to instability of the appliance, it must be placed at an even or flat surface.

Getting to Know Your Unit

Components:

• 1. Float Switch
• 2. Secondary Water Reservoir (It connects directly with the evaporator)
• 3. Water Reservoir
• 4. Maximum Water Level
• 5. Filter
• 6. Control Panel: A. Ice making and cleaning buttons; B. Ring indicator light; C. Water lack indicator light; D. Ice full indicator light
• 7. Top Cover (removable from the top)
• 8. Hot Air Outlet
• 9. Ice Basket
• 10. Water Drain Cap (at the front bottom side of the unit)
• 11. Ice Scoop

A diagram shows the different parts of the ice maker, including the top cover, ice basket, water reservoirs, control panel, and drain cap.

Operating Procedures & Maintenance

1. Remove both the exterior and interior packaging, and then check to ensure that all the accessories are included. If any of the parts are missing, please contact customer service for assistance.
2. Remove all the tapes from the unit and take out the accessory parts inside.
3. Clean the interior with lukewarm water and a soft cloth.
4. Place your ice maker on a level counter or table, away from direct sunlight and other sources of heat (i.e., stove, furnace, and radiator). Make sure that at least 6 inches are between the back and sides of your ice maker and the wall.
5. Allow one hour for the refrigerant fluid to settle before plugging your ice maker in.
6. Ensure that the power plug is easily accessible.

WARNING: Fill with potable water only. Only use drinking water.

DANGER

*Improper use of the grounded plug can result in electrical shock. If the power cord is damaged, please contact customer service.

1. To ensure your safety, it's important to ground this unit properly. The power cord comes with a grounding plug that fits standard grounding wall outlets, which helps reduce the risk of electric shock.
2. Always plug your appliance into a dedicated, well-installed grounding wall outlet. Do not damage the plug's grounding means under any circumstances. If you have any questions concerning power and grounding, seek advice from a certified electrician.
3. This appliance requires a standard 110-120Volt, 60Hz electrical outlet with proper grounding means.

Using Your Ice Maker

Initial Cleaning

Before using your ice maker, it is strongly recommended to clean it thoroughly. Unplug the unit before cleaning or making any maintenance.

1. Take out the ice basket.
2. Clean the interior with diluted detergent, warm water, and a soft cloth.
3. Rinse the inside parts with water and drain out the water by unplugging the drain cap located on the bottom front side.
4. Use a mild detergent solution and warm water to clean the exterior of the ice maker regularly.
5. Dry the interior and exterior with a clean, soft cloth.
6. If the machine is not going to be used for a long time, drain the water entirely & dry the interior.

How to start the unit

1. Remove the top back cover and the power cord. Then, replace the top cover.
2. Take out the ice basket and pour potable water into the water reservoir. Ensure that you do not exceed 0.3-gallon water.
3. Put the ice basket back in place.
4. Plug in the unit. The ring indicator will turn red. To start making ice, press the "ice/clean" button.

Cleaning Procedure

We recommend running the initial cleaning procedure before using the appliance for the first time or if the device has not been cleaned in a long time. Here are the steps to follow:

1. Before cleaning, make sure to insert the water drain cap into the appliance to ensure it works properly.
2. Press and hold the “ICE/CLEAN” button for 5 seconds. The cleaning procedure will be activated when the Ring indicator light flashes white. After running for 15 minutes, the process will automatically exit. To interrupt the process, simply press the “ICE/CLEAN” button again, and it will exit immediately.
3. After the cleaning procedure, remove the top cover and ice basket. Rinse the main water reservoir and the secondary water reservoir. Then, move the appliance to the edge of the desktop and ensure it is placed steadily.
4. Place a water container under the appliance and remove the drain cap from the bottom to collect dirty water. When the process is done, reinsert the drain cap.
5. Repeat steps 4 to 6 with fresh water for two more cycles to rinse the inside.
6. Replace the drain cap on the bottom.
7. After completing the cleaning process, fill the reservoir with fresh water and press the "Ice/Clean" button to start making ice cubes.

System Cleaning/Sanitizing Procedure

1. Unplug the ice maker.
2. Take off the bottom drain cap and drain out the water to a sink.
3. For daily cleaning, dilute one teaspoon of household bleach in five cups of water.
4. For monthly cleaning of removing mineral deposits, use white vinegar instead of the water solution mentioned above (and then plug in to turn on the "cleaning function" for about 5 minutes. After that, unplug it again to leave the white vinegar in the unit for at least 12 hours).
5. Pour the solution into the water reservoir up to the “MAX” water level.
6. Plug in the ice maker, press and hold the "Ice/Clean" button for 5 seconds to initiate the cleaning process (15 mins).
7. When the "Ice/Clean" indicator turns off, remove the drain cap and drain the water into a sink.

How to obtain the ice cube

1. Before making ice, make sure to insert the water drain cap into the appliance to ensure it works properly.
2. Press and hold the “ICE/CLEAN” button for 5 seconds. The ice making procedure will be activated when the Ring indicator light flashes white. To interrupt the process, simply press the “ICE/CLEAN” button again, and it will stop immediately.
3. We recommend running the initial cleaning procedure before using the appliance for the first time or if the device has not been cleaned in a long time.
4. If the "Add water" light is on and the ice machine stops working, add water and restart it. Otherwise, it will take a long time to start automatically. After restarting, the compressor will have a 3-minute waiting time before making ice again.
5. When the ice bin is full, the machine stops and the "ice full" light turns on. It resumes automatically once the ice is removed.

Ice scoop position

Put the scoop on the top back cover.

A diagram illustrates the ice scoop placement on the ice scoop holder on the top back cover.

Troubleshooting

Technical Parameters & Circuit Diagram

Technical Parameters

• Model: IM-15S
• SKU: IM-15S-AZ-HM
• Protection Type: |
• Power: 115V/60Hz
• Ice Making Current: 2.7A
• Refrigerant: R600a, 0.57Oz / 16g
• Vesicant: C5H10
• Dimension: 287x220x322mm

A diagram shows the electrical and circuit diagram of the ice maker, including components like the compressor, fan motor, water level detecting switch, and various relays and protectors.