63' Diamond User Manual
NUX Reissue Series
Safety Precautions
- Please use the unit at the indicated voltage. Using it at other voltages may cause fire, electric shock, or damage.
- Do not open, disassemble, or modify the unit's back cover or casing. This may cause fire, electric shock, or damage. For repairs, please contact your dealer.
- Avoid using the unit in humid environments, high-temperature locations, or direct sunlight.
- Disconnect the unit when not in use for extended periods.
- The manufacturer assumes no responsibility for damages resulting from fire, earthquake, acts by third parties, other accidents, customer's intentional or negligent acts, misuse, or other abnormal conditions.
- This product complies with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
- Please keep this user manual for future reference.
- Trademarks of other manufacturers are used solely for reference to express sound modeling tones. They are trademarks or registered trademarks of their respective companies and are not affiliated with NUX.
Features and Names
Overview
- Analog Circuit
- Classic knobs and panel design
- Top boost toggle
- True-bypass hardware switching
Pedal Layout and Functions
The 63' Diamond pedal is inspired by the VOX AC-30 model. The Volume and Master knobs evoke the golden age of rock and roll, while the Top Boost toggle switch reproduces the characteristic high-frequency boost of the AC series.
Component Descriptions:
- 1. POWER Jack:
- Connect a 9V, center-negative power supply (AC adapter). The NUX ACD-006A adapter is recommended. A supply of 300mA or higher is recommended.
- 2. VOLUME Knob:
- Adjusts the amount of distortion.
- 3. MASTER Knob:
- Adjusts the output level (volume).
- 4. CUT Knob:
- Adjusts high frequencies.
- 5. TOP BOOST Toggle Switch:
- Switches the high-frequency boost ON/OFF.
- 6. OUTPUT Jack:
- Connect to amplifier cable. (Output)
- 7. INPUT Jack:
- Connect to guitar cable. (Input) Plugging into this jack turns the pedal ON. Disconnect the plug when not in use.
- 8. LED Indicator:
- Lights up when the effect is ON.
- 9. ON/OFF Switch:
- Switches the effect ON/OFF.
Battery Usage
The 63' Diamond can also be powered by a 9V battery (006P type). Connect the battery to the snap cord and store it in the battery compartment.
When the battery is low, the sound will change. Please replace it with a new battery.
The battery will drain if a plug is connected to the INPUT Jack. Please disconnect the plug when not in use.
Due to relatively high power consumption, using an AC adapter is recommended.
Battery Installation Illustration Description:
The illustration shows a 9V battery and the pedal's battery compartment. The battery is connected to a snap cord, which is then plugged into the pedal's internal connector. The compartment cover is shown being closed.
Product Specifications
| Specification | Value |
|---|---|
| Input impedance | 1M Ohms |
| Output impedance | 1K Ohms |
| Current draw | < 10 mA |
| Power | 9V battery or external AC adaptor delivering 9V DC regulated minimum 300mA |
| Dimensions | 121(L) X 77(W) X 48(D) mm |
| Weight | 230g |
| Accessories | User Manual (this document) |
Specifications are subject to change without notice.
Website: www.nuxefx.com
Country of Manufacture: Made in China
