KOHLER Archer® 61-3/4" Freestanding Heated BubbleMassage™ Air Bath
Model: K-2593-GH
Key Features
- 118 to 122 airjets release thousands of heated bubbles for a warm massage.
- Automatic and manual purge cycles remove residual water from air channels after use.
- Variable-speed blower allows massage intensity adjustment across 18 levels.
- Freestanding design creates a striking focal point.
- Integral lumbar support for comfort.
- Slotted overflow allows for deep soaking.
- Coordinates with other products in the Archer collection.
- Built-in 600W BubbleMassage™ heater warms humidified air before it enters the bath.
Material and Technology
Material: Acrylic
Technology:
- Auto-shutoff timer on blower allows users to enjoy the Heated BubbleMassage™ experience for 60 minutes before turning off.
- User interface: Electronic keypad control.
Installation
- Freestanding installation.
- Reversible drain.
- End ledge allows for deck-mounting capabilities for faucets.
- Note: PureFlo drains are not recommended for a deck-mount faucet installation.
Codes and Standards
- ASME A112.19.7/CSA B45.10
- CSA B45.5/IAPMO Z124
- ASTM E162
- ASTM E662
- UL 1795
- CSA C22.2 No. 218.2
Warranty
KOHLER® Plastic Baths and Shower Bases Lifetime Limited Warranty
KOHLER® Hydrotherapy Components Five-Year Limited Warranty
See website for detailed warranty information: www.kohler.com
Required Products/Accessories
- K-7271 Brass Slotted Overflow Bath Drain
- or
- K-7272 PVC Slotted Overflow Bath Drain
Recommended Products/Accessories
- K-23726 Drain treatment
- K-23732 Tub & shower cleaner
- K-31797 Slotted overflow bath drain kit
- K-31795 Slotted overflow above-the-floor bath drain kit
Technical Information
All product dimensions are nominal.
Installation Details
- Installation Type: Freestanding
- Drain Location: Reversible
Dimensions and Capacity
| Specification | Value |
|---|---|
| Overall Length | 61-3/4" (1503 mm) [approx. from diagram] |
| Overall Width | 32" (813 mm) [approx. from diagram] |
| Basin Area, Bottom | 45-1/8" x 19-11/16" (1146 mm x 500 mm) |
| Basin Area, Top | 52-3/4" x 25-5/16" (1340 mm x 643 mm) |
| Water Depth | 15-1/16" (383 mm) |
| Water Capacity | 58 gal (219.6 L) |
| Weight | 105 lbs (47.6 kg) |
| Minimum Floor Load | 43.8 lbs/ft² (213.9 kg/m²) |
Diagram Descriptions
Bath Diagram
The bath is a freestanding unit with rounded corners and integral lumbar support angled at 24 degrees. Key dimensions from the diagram include an overall length of 62 inches (1575 mm) and a width of 32 inches (813 mm). The basin bottom measures approximately 45-1/8 inches by 19-11/16 inches (1146 mm x 500 mm), and the basin top measures approximately 52-3/4 inches by 25-5/16 inches (1340 mm x 643 mm). The water depth is 15-1/16 inches (383 mm).
Recommended Faucet Location Diagram
This diagram illustrates recommended faucet placement on the bath rim. Measurements indicate placement from the edges: approximately 13-3/4 inches (349 mm) from the back edge and 16 inches (406 mm) from the side edge for the primary faucet hole. It also shows spacing for additional holes, with distances like 2 inches (51 mm) and 8 inches (203 mm) between centers.
Electrical Requirements
Two dedicated circuits are required, protected with a Class A Ground-Fault Circuit-Interrupter (GFCI). Outside North America, this device may be known as a Residual Current Device (RCD).
- Blower: 120 V, 15 A, 60 Hz
- Heater: 120 V, 15 A, 60 Hz
Note: Electrical component blower listed as 120 V, 10 A, 60 Hz in one instance.
Notes
- Measure your actual product for rough-in details.
- Install this product according to the installation instructions.
- The hot water supply should be 70% of the capacity of the bath or greater; installations will vary.
- This bath is designed for freestanding installation only.
- If installing a rim-mount faucet, ensure there is no interference above or below the deck before drilling any holes.
KOHLER Kitchen and Bathroom
