Sunstruck® Freestanding BubbleMassage™ Air Bath
Model: K-1967-G
Key Features
- 118 to 122 airjets release thousands of bubbles that surround, support, and massage the body.
- Variable-speed blower allows adjustment of massage intensity to 18 levels.
- Freestanding design creates a striking focal point in the bathing area.
- 16-inch depth offers a deep soaking experience.
- Integral lumbar support.
- Textured bottom surface.
- Wide ledge on one side is ideal for deck-mount faucet and/or handshower.
- Purge cycles remove residual water from air channels after use.
- Center drain.
Material & Hydrotherapy
Material
- Acrylic.
Hydrotherapy
- BubbleMassage.
Installation
- Freestanding installation.
- PureFlo drains are not recommended for a deck-mount faucet installation.
Dimensions and Installation Guidance
Overall Dimensions
The tub has a freestanding design. Key dimensions include:
- Overall Length: 65-1/2" (1664 mm)
- Overall Width: 32-3/4" (832 mm)
- Height (to top edge): 19-1/2" (495 mm)
- Side Height (at widest point): 6-1/16" (154 mm)
- Base Width: 24-1/2" (622 mm)
Faucet Location and Drain
Recommended faucet hole locations are indicated with specific measurements for spacing. The bath drain is centrally located.
- Faucet Hole Spacing (center-to-center): 8-7/16" (214 mm)
- Faucet Hole Diameter: 4" (102 mm)
- Drain Location: Center
- Drain Diameter: 1-1/2"
Lumbar Support and Depth
The tub features integral lumbar support, with lumbar angles indicated as 19 degrees. The tub depth is 16 inches (406 mm).
Subfloor Clearance
A minimum subfloor clearance of 1/2" (13 mm) is required for drain tee clearance. Note: Horizontal PVC pipe and tee are shown for illustration and are not included.
Technical Information
- Installation Type
- Freestanding
- Drain Location
- Center
- Basin Area, Bottom
- 45-3/4" x 24-7/8" (1162 mm x 632 mm)
- Basin Area, Top
- 54-7/8" x 29-3/16" (1394 mm x 741 mm)
- Weight
- 91 lbs (41.3 kg)
- Minimum Floor Load
- 40.4 lbs/ft² (197.3 kg/m²)
- Water Depth
- 16" (406 mm)
- Water Capacity
- 72.6 gal (274.8 L)
- Template
- Footprint, 1245667, not required, not included
Required Electrical Service
One dedicated circuit is required, protected with a Class A Ground-Fault Circuit-Interrupter (GFCI). Outside North America, this device may be known as a Residual Current Device (RCD).
Blower requirements: 120 V, 15 A, 60 Hz
Electrical component rating: Blower: 120 V, 10 A, 60 Hz
Codes and Standards
- ASME A112.19.7/CSA B45.10
- CSA B45.5/IAPMO Z124
- UL 1795
- CSA C22.2 No. 218.2
Warranty Information
- KOHLER® Plastic Baths and Receptors: Lifetime Limited Warranty
- KOHLER® Hydrotherapy Components: Five-Year Limited Warranty
Refer to the Kohler website for detailed warranty information.
Recommended Products/Accessories
- K-7265 Clearflo Bath Drain
- K-37383 Rough-in cable bath drain, PVC, 30" cable with tubing
- K-37386 Rough-in cable drain, PVC, 30" cable
- K-24916 Wireless Music Kit
- K-23726 Drain treatment
- K-23732 Tub & shower cleaner
Available Colors/Finishes
Color tiles are intended for reference only.
| Color Code | Description |
|---|---|
| 0 | White |
| 96 | Biscuit |
Important Notes
- Measure your actual product for rough-in details.
- Install this product according to the installation instructions.
- The hot water supply should be 70% of the capacity of the bath or greater. Installations will vary.
- Remote blower motor installation is required. A relocation kit is included.
- If installing a rim-mount faucet, ensure there is no interference above or below the deck before drilling any holes.
