Tork PeakServe® Continuous Hand Towel Dispenser
Model: H5 | Design: Elevation Design
Product Overview
The Tork PeakServe® Continuous Hand Towel Dispenser is designed for high-traffic environments, offering a continuous supply of towels. This guide covers installation and maintenance for the Model H5 with Elevation Design.
Installation Instructions
Required Tools and Components
⚠️ Important Safety Warning: To avoid electrical shock hazards, do not install the dispenser directly above an electrical outlet or within 6 inches (15 cm) of any edge of an electrical outlet. Ensure users do not need to reach over an electrical outlet to access the dispenser. Installers are responsible for ensuring compliance with all applicable building and electrical codes.
-
Step 1: Mark Mounting Position
Determine the desired mounting height. The dispenser requires approximately 70 inches (178 cm) of vertical space from the mounting bracket to the bottom of the dispenser. Use a spirit level to mark the horizontal line for the wall mount bracket. Ensure the bracket is positioned at least 6 inches (15 cm) away from any electrical outlet.
? [Spirit Level] [Marking Tool]
-
Step 2: Attach Wall Mount Bracket
Align the wall mount bracket with the marked line. Mark the screw hole positions. Drill holes at the marked positions. If mounting into drywall, insert appropriate wall anchors. Secure the bracket to the wall using the provided screws. Ensure the bracket is firmly attached.
ड्रिल [Drill] ? [Screws] [Wall Anchors]
-
Step 3: Mount the Dispenser
Align the dispenser with the mounted bracket. Slide the dispenser down onto the bracket until it clicks into place. Ensure it is securely attached.
[Dispenser] [Bracket]
-
Step 4: Secure the Dispenser
Some models may have a locking mechanism or screw to secure the dispenser to the bracket. Use the provided key ? to lock or secure the dispenser if applicable.
? [Lock Symbol]
-
Step 5: Open the Dispenser
Use the key ? to unlock and open the front cover of the dispenser.
? ? [Unlock Symbol]
-
Step 6: Load Towel Roll
Take a Tork PeakServe® towel roll (Model H5). Place the roll into the dispenser, ensuring it is seated correctly on the spindle.
[Towel Roll]
-
Step 7: Prepare Towel Tail
Pull the end of the towel tail through the dispensing slot. Leave a small portion of the towel hanging out.
[Towel Tail]
-
Step 8: Close the Dispenser
Close the front cover of the dispenser. It should click shut. Ensure it is properly closed and locked.
? [Close Symbol]
-
Step 9: Final Check
Test the dispenser by pulling a towel. Ensure it dispenses smoothly. The dispenser is now ready for use.
[Dispense Action]
-
Step 10: Ready for Use
The Tork PeakServe® Continuous Hand Towel Dispenser is installed and ready for use.
Care and Maintenance
Regular care ensures optimal performance and hygiene.
Daily Care
Dust the dispenser daily with a soft, lint-free cloth.
Cleaning
For general cleaning, use a clean, damp cloth. A solution of mild soap and water can also be used. Avoid abrasive materials or paper, as they can scratch the surface.
Monthly Maintenance
At least once a month, it is recommended to remove paper dust from inside the dispenser. This can be done using a vacuum cleaner or compressed air. Always wear eye protection ? when using compressed air.
? [Vacuum] ? [Compressed Air] ? [Eye Protection]
Disposal
Damaged or malfunctioning products should be disposed of immediately to avoid potential injury. Products must be disposed of in accordance with all applicable local and national regulations.
Manufacturer Information
Manufactured for: Essity Professional Hygiene North America LLC
Address: Philadelphia, Pennsylvania 19104
Websites: www.essity.com, www.torkusa.com
Made in Poland
For patents, visit: www.essity.com/patents
