LUTEC 7621101053 Wet Location Flood Light

Installation and Operation Manual

Please read and understand this entire manual before attempting to assemble, operate, or install the product.

WARNING/AVERTISSEMENT/ADVERTENCIA

• Consult a qualified electrician if you are not certain about the installation process. Always install wiring connections in accordance with the local code, ordinances, and the National Electric Code.
• Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
• Do not attempt to install this product while it is plugged in.
• Do not connect this light fixture to a dimmer switch or timer.
• This light fixture is designed to fit standard junction boxes as defined by the National Electrical Code.
• After turning on the switch, temperature of bulb rises gradually. Do not touch bulb with bare hands until bulbs have completely cooled. When changing the bulb, first turn off the power and allow the bulb to completely cool.
• The bulb must not exceed the specified wattage.
• To control the floodlight manually, the control must be wired through a switch.
• To avoid water damage and the risk of electrical shock, the motion sensor controls must be facing the ground when installation is complete.
• Do not install motors, transformers, or fluorescent light fixtures on the same circuit as the fixture.

Installation Steps

1. Step 1: Ensure power is OFF at the breaker.
2. Step 2: Mount the bracket to the junction box.
3. Step 3: Connect the wires according to the diagram (Black to Black, White to White, Ground to Ground).
4. Step 4: Attach the fixture to the bracket.
5. Step 5: Adjust the sensor and light heads.
6. Step 6: Turn power ON at the breaker.
7. Step 7: Test the motion sensor.
8. Step 8: Adjust the detection angle and range as needed.
9. Step 9: Manual override can be activated by flipping the wall switch off and on within 3 seconds.

Mode Settings

TEST Mode

The sensor will detect movement and the light will activate regardless of time of day. After movement has stopped or left the coverage area, the light will remain on for about 5 seconds, then turn off.

SECURITY (DISTANCE) Mode

At dusk, the motion sensor becomes active. Any movement within the coverage area will cause the light to turn on. After movement has stopped, the light will remain on for the preset time limit of 1, 3 or 10 minutes, then turn off. The motion sensor will remain active throughout the night. At dawn, the motion sensor will deactivate and remain deactivated throughout the day. Movement will not cause the light to turn on.

Notes

• The sensor has a 14 second warm-up period before it will detect motion. Please wait 14 seconds after turning on the unit.
• Manual Override: Force the fixture to override TEST and SECURITY modes so the light will stay on. Turn the light on manually from the wall switch. In SECURITY mode: with the fixture already in the ON position, flip the wall switch off and then back on in 3 seconds. To revert back to the previous mode, flip the wall switch off, wait for 10 seconds, and then back on. If you leave the light on, it will stay on for about 6 hours.

Specifications

• Detection Range: 20-70 ft.
• Detection Angle: 180°
• Adjustable Heads: Yes
• Wattage: Bulb not included, designed for bulbs up to specified wattage.

Service Information

LUTEC USA LLC:
149B Houston Rd Troutman NC 28166

Ningbo UTEC Electric Co.,LTD
CN8, Far East Industry Park, Yuyao, China

Website: www.lutec.com