IKEA LÅNGDANS Roller Blind Assembly Instructions

Important Information

As wall materials vary, screws for fixing to the wall are not included. For advice on suitable screw systems, contact your local specialised dealer.

Tools required: Screwdriver, spirit level, scissors, pencil, measuring tape, hacksaw.

Parts Included

• 2x Mounting brackets (Part no. 10094493)
• 1x Roller blind assembly
• 1x Bottom rail
• 1x Pull handle
• 2x End caps (Part no. 10094632)

Assembly Steps

1. Measure and Mark: Determine the desired position for the roller blind. Ensure a minimum clearance of 5 cm (1 15/16") from the top of the window frame and 5 mm (3/16") from the ceiling or wall above. Mark the bracket positions on the wall or window frame.
2. Attach Brackets: Securely attach the mounting brackets to the wall or frame using appropriate screws (not included). Ensure they are level.
3. Prepare the Blind: If necessary, cut the bottom rail to the desired width using a hacksaw. Measure and mark the cutting line on the bottom rail, ensuring a 35 mm (1 3/8") margin from the edge for the pull handle attachment.
4. Attach Bottom Rail: Insert the bottom rail into the fabric hem of the roller blind.
5. Install the Roller Blind: Align the roller blind assembly with the mounting brackets. Push the blind into the brackets until it clicks into place.
6. Attach Pull Handle: Insert the pull handle into the designated slot on the bottom rail.
7. Adjust and Secure: Ensure the blind is hanging straight. If needed, adjust the position of the brackets.
8. Final Check: Test the operation of the roller blind.

Dimensions and Adjustments

For the LÅNGDANS roller blind:

• When cutting the fabric, ensure a margin of 35 mm (1 3/8") from the edge for the bottom rail.
• The maximum length for the pull cord (Z) is 150 mm (5.9") for blinds between 800-1400 mm (31.5-55.1") wide.
• For blinds 600 mm (23.6") wide, there are no specific restrictions on the pull cord length mentioned.

Disposal

Dispose of packaging materials responsibly according to local regulations. The product itself should be disposed of at designated collection points for electronic waste.