Emerson Indoor Flying Insect Trap Quick Reference Guide
Model: ITL9905RE
The Glue Cards are designed for use with Emerson Indoor Flying Insect Trap model ITL5107 (sold separately). It is highly recommended to fully read the main owner's manual of ITL5107 to receive the full safety instructions and operation procedures.
Directions for Use
The insect trap works by using a continuous, attractive light to draw insects. Once they are enticed, they are caught by a highly effective sticky paper, preventing their escape.
Insect Trap Mode
-
Remove the adhesive liner from the Glue Card and discard it. Insert the Glue Card into the device with the glue facing the back.
[Illustration shows a Glue Card with an arrow indicating insertion into a device slot, with the sticky side facing the back.]
-
Plug the device into an indoor outlet. Press the ON/OFF touch switch. To optimize the performance, leave the unit powered on continuously.
[Illustration shows the device being plugged into an outlet.]
-
The plug on the device can be rotated if necessary. ALWAYS UNPLUG BEFORE ROTATING THE PLUG.
[Illustration shows the device plug being rotated. A warning symbol [!] is shown next to the instruction to unplug before rotating.]
-
Replace the Glue Card when it is full of bugs, dust or debris. It is advisable to check every 2 weeks.
[Illustration shows a device with a full Glue Card, a trash can ?️, and a new Glue Card being inserted. An arrow indicates the removal of the old card.]