LogiLink PA0290 Solar Power Bank - User Manual

Introduction

Congratulations on your purchase of the PA0290 portable power bank! Please read the user and safety instructions before first use to avoid damage.

Symbols and Warnings Used

This user manual contains the following symbols and warnings:

• DANGER!: Indicates a high level of risk that, if not avoided, will result in severe personal injury or death.
• WARNING!: Indicates a medium level of risk that, if not avoided, could result in severe personal injury.
• CAUTION!: Indicates a low level of risk that, if not avoided, could result in minor or moderate injury.
• ATTENTION!: Indicates the possibility of material damage.
• WARNING! EXPLOSION HAZARD!: This symbol and the warning text "WARNING! EXPLOSION HAZARD!" indicate a potential explosion hazard. Failure to heed this warning can cause severe injury or death and potential material damage. Follow the instructions associated with this warning to prevent severe injury, danger to life, or material damage!
• NOTE:: This symbol with the signal word "NOTE" contains additional useful information.
• This symbol means that the product instructions must be followed when using the product. [Instructions Icon]
• Direct Current (DC) symbol. [DC Symbol]

Intended Use

This product is an IT device intended exclusively for charging mobile devices that are typically charged via USB ports. This product is not intended for commercial use. The manufacturer is not responsible for damage caused by unforeseen use.

Trademark Notice

• USB® is a registered trademark of the USB Implementers Forum, Inc.
• The LogiLink trademark and trade name are the property of their respective owners.
• All other names and products may be trademarks or registered trademarks of their respective owners.

Package Contents

• Portable power bank 1x
• USB charging cable 1x
• User manual 1x

First Use Steps

Remove all packaging from the product and ensure the package contents are not damaged. If you notice any damage or missing parts, contact the retailer where you purchased the product.

Manufactured to the best of our knowledge and with the utmost care. We reserve the right to errors and technical changes.

Device Components and Parts Description

The following components are part of the device:

• A: Power button
• B: Waterproof cover
• C: USB-A output (x2)
• D: USB-C input
• E: Green LED solar charging indicator
• F: Blue LED battery status indicators
• G: Solar cells
• H: Flashlight (3 modes: steady light/SOS/strobe)
• I: Belt clip
• J: User manual
• K: USB-C to USB-A cable

Diagram Description: The diagram shows the power bank from different angles, illustrating components A through K. It displays the power button, waterproof cover, USB ports (USB-A and USB-C), solar cells, flashlight, and belt clip. It also shows the included USB-C to USB-A cable and a representation of the power bank with its model number PA0290.

Technical Specifications

Power adapter not included in delivery.

Safety Instructions

Before using the device, familiarize yourself with all operating and safety instructions. If you pass the device on to third parties, be sure to include all documentation.

• Before using the device, check for any visible external damage. Do not use the device if it is damaged or has been dropped.
• The device can be used by children aged 8 and over, and by persons with reduced physical, sensory, or mental capabilities or with insufficient experience and knowledge, if supervised by a person responsible for their safety or if they have received instructions for safe use and understand the associated risks.
• The device and its connecting cord must not be accessible to children under 8 years of age.
• Children must not perform cleaning and maintenance of the device unless they are 8 years of age or older and supervised.
• Do not allow children to play with the device.
• DANGER! Packaging materials are not toys. Keep all packaging materials out of reach of children. Risk of suffocation! [Suffocation Hazard Icon]
• Always use the device on a level and smooth surface. The device may be damaged if dropped.
• Do not expose the device to high temperatures. Otherwise, it may overheat, leading to irreparable damage.
• Do not use the device near open flames, such as candles.
• The device is not intended for use in areas with high temperatures or humidity (e.g., in bathrooms) or in areas with high dust content.
• Do not expose the device to extremely high temperatures. This is especially important if you intend to store the device in a car. Cars can get very hot over extended periods. Remove electrical devices from the car.
• Do not use the device immediately after moving it from a cold to a warm environment. Allow the device to acclimatize to the ambient temperature before switching it on.
• WARNING! Never open the device casing. This device has no user-serviceable internal parts.
• WARNING! Improper handling of lithium-polymer batteries can cause fire, explosions, leakage of hazardous substances, or other dangerous situations! Do not throw the device into a fire, as this can cause the built-in battery to explode.
• Do not modify or alter the device yourself.
• Repairs to the device may only be carried out by authorized specialized companies or the customer service department. Incorrect repairs could put the user in great danger. Furthermore, the warranty will be voided.
• If you detect a burning smell or see smoke, immediately switch off the device and remove the charging cable. Have the device inspected by a qualified technician before further use.
• If using a USB power adapter, the socket used must always be easily accessible so that the USB power adapter can be quickly disconnected from the socket in an emergency. Refer to the manufacturer's operating instructions.
• Observe the restrictions and prohibitions for using battery-powered devices in potentially hazardous environments, such as at petrol stations, airports, hospitals, etc.
• WARNING! Be careful not to cover the device during the charging process. There is a risk of heating and overheating.
• Due to high power consumption, the portable power bank should not be charged from a personal computer or laptop.
• CAUTION! Solar cells are intended for emergency charging only and should not be the primary charging source. Prolonged exposure to the sun will damage the solar cells.
• The charging time required for the portable power bank depends on the charging source and its output power.
• ATTENTION! When the portable power bank is charging, do not connect any device to be charged. Remove the charging cable from the portable power bank once it is fully charged.

Operation and Use

Charging the Portable Power Bank

Fully charge the built-in portable power bank before first use.

• To charge the portable power bank via USB cable, use power adapters with a 5 V output voltage and at least 2 A output current.
• 1. Connect the USB cable (K) to the USB-C input (D) of the portable power bank.
• 2. Connect the other end of the USB cable (K) to a USB power adapter (not included in delivery) (see Figure L).
• 3. The portable power bank will automatically start charging via the solar cells (G) when exposed to sunlight.

The green LED indicator for solar charging lights up during solar charging. When the portable power bank is fully charged, the blue LED indicator lights up.

The battery charging status is indicated by LED indicator (F):

* This is an approximate percentage of the portable power bank's capacity, not an actual measurement.

Checking Battery Status

You can check the battery status at any time using the LED indicator (F).

• Press the power button (A). The LED indicator (F) will display the current battery status of the portable power bank for approximately 30 seconds, based on the 4 LED indicators (F) showing the total capacity.

* This is an approximate percentage of the battery's capacity, not an actual measurement.

Charging Mobile Devices with the Portable Power Bank

1. Use the included USB cable (K) or another charging cable purchased from a reliable supplier. Connect the Type-A USB connector to the USB output of the portable power bank.
2. Connect the other end of the USB cable (K) to the USB device you wish to charge. The charging process will start automatically.
3. If the charging process does not start immediately, briefly press the power button (A) to initiate it. The current battery status of the portable power bank is displayed by the LED indicator (F) during the charging process.
4. To end the charging process, remove the USB charging cable from the USB device and the portable power bank. The LED indicator (F) will turn off after approximately 30 seconds.

When charging two devices simultaneously, all outputs will provide 5 V voltage and a maximum power of 10 W.

Flashlight

1. To turn on the flashlight (H), press and hold the power button (A) for 2 seconds.
2. To activate the strobe light, press the power button (A) again.
3. After the strobe, press the power button (A) again to activate the SOS call light.
4. Press and hold the power button (A) for 2 seconds to turn off the flashlight.

Troubleshooting

Problem: Portable power bank does not charge.

• Cause: Portable power bank may not be connected correctly.
• Solution: Check the connection. A power adapter with 5 V voltage and at least 2 A current is required to charge the portable power bank.

Problem: Connected device does not charge.

• Cause: Battery is depleted.
• Solution: Charge the battery.

Problem: Device is not connected.

• Solution: Check if the device is connected. Briefly press the power button (A) to start the charging process.

Problem: The current consumption of the connected device may be too low.

• Solution: Check the user manual of the connected device and verify if its current consumption is compatible with this product.

Problem: Portable power bank does not respond when the button is pressed or a device is connected, even though the battery is charged.

• Cause: The current consumption of the connected device is too high. The internal overcurrent protection has been activated.
• Solution: Disconnect the device you wish to charge and find a more suitable portable power bank for charging.

Cleaning and Care

This device has no user-serviceable internal parts. Moisture entering the product can cause damage.

• Ensure that no moisture enters the product during cleaning, as this could cause irreparable damage.
• Do not use abrasive cleaners, solvent-based cleaners, or aggressive cleaning agents. These can damage the device's surface.
• Clean the device only with a slightly damp cloth and mild dish soap.
• Ensure all sockets are free of dirt and foreign objects.

Storage

• Store the device in a dry, dust-free place, protected from direct sunlight.
• If you do not plan to use the device for an extended period, fully charge the built-in battery to extend its lifespan.
• If the device is not used for a long time, charge the built-in battery regularly. This is essential for maintaining battery performance.

Disposal

• The packaging is made of environmentally friendly materials that can be returned to local recycling facilities.
• For information on how to dispose of the used device, contact your local municipality.

The built-in rechargeable battery cannot be removed for disposal.

Note on EU Declaration of Conformity

The CE marking confirms that this product complies with the essential requirements of Directive 2014/30/EU of the European Parliament and of the Council of Europe concerning electromagnetic compatibility. The product is equipped with the CE conformity mark. Corresponding declarations are held by the manufacturer.

2direct GmbH, Langenstück 5, D-58579 Schalksmühle, Germany

The original EU Declaration of Conformity and its translation into Slovenian can also be found at the end of these user instructions.

Limitation of Liability

The product has been manufactured according to strict quality guidelines and has been carefully inspected before dispatch. In case of product defects, you have statutory rights against the seller of this product.

The warranty becomes void if the product has been damaged, used improperly, or maintained incorrectly.

The warranty covers material or manufacturing defects. The warranty does not cover parts subject to normal wear and tear, considered consumables (e.g., batteries), or damage to fragile parts such as switches, rechargeable batteries, or glass components.

In case of functional or other defects, please contact the seller. Information is provided on the back page of these user instructions.

Service Contact Information

LogiLink Service Department

• Hotline: 10:00 to 18:00 (+49) 2351-66887-19 (German landline number)
• Email: support@logilink.com

2direct GmbH
Langenstück 5
58579 Schalksmühle
Germany

• Phone: +49 2351 66887-0
• Fax: +49 2351 66887-29
• Email: info@2direct.de
• Website: http://www.logilink.com

Warranty Card

Product: LogiLink PA0290 Portable Solar Power Bank

Cat. No.: 27 98 730

Warranty Statement: Conrad Electronic d.o.o. k.d. warrants the quality and flawless operation within the warranty period, which begins upon delivery of the goods to the consumer. The warranty is valid within the territory of the Republic of Slovenia. The warranty for the product is 1 year.

For products sent for repair, the defect resolution period is 30 days, with the possibility of extension, but not exceeding 15 days if the defect cannot be resolved within the initial period. In case of inability to resolve the defect, the product will be replaced with an identical new and flawless one, or as stipulated by law. Defects due to non-compliance with the enclosed instructions, improper use, negligent handling of the product, and mechanical damage are excluded from the warranty conditions.

In case of non-conformity, the consumer has the statutory right to free warranty claim. The warranty does not exclude consumer rights arising from the mandatory warranty for product conformity.

Maintenance, spare parts, and connection accessories are guaranteed by the manufacturer for 3 years after the warranty expires. Servicing is carried out by CONRAD ELECTRONIC SE, Klaus-Conrad-Strasse 1, 92240 Hirschau, Germany.

Send defective products free of charge (at our expense) to the following address: Conrad Electronic d.o.o. k.d., Pod Jelšami 14, 1290 Grosuplje. The warranty can be claimed without presenting the warranty card – if you provide the invoice/delivery note number.

Warranty Provider: Conrad Electronic d.o.o. k.d.

Date of Sale Delivery: ______________________________

The warranty is machine-generated and valid without stamp and signature from the date of product delivery.

EU Declaration of Conformity

EC Declaration of Conformity

This declaration of conformity is issued under the sole responsibility of the manufacturer.

In accordance with the provisions 2014/30/EU (EMC) & 2015/863/EU (RoHS3)

Importer / Distributor:

2direct GmbH
Langenstück 5
58579 Schalksmühle
Germany

declares that the product:

Brand Name: LogiLink
Model Number: PA0290
Product Description: Portable Power Bank, LiPo, 6,000 mAh, solar, with flashlight

is in Conformity with the following European Standards:

• EN 55032:2015/A1:2020
• EN 55035:2017/A11:2020
• EN IEC 55015:2019/A11:2020
• EN 61547:2009
• EN 63000:2018

Report No: 6876022090401

Identification of signatory empowered to bind the manufacturer or his authorized representative.

Schalksmühle, 10th February 2023

Place and date of issue

Signature General Manager (Wilfried Grohnert)