Kärcher VC 4 Cordless myHome & VC 4 Cordless Premium myHome Quickstart

Section A: Wall Mounting

Step 1: Prepare for wall mounting.

Using a drill ?, create two holes in the wall at a height of 1.04 meters. Insert screws into the holes to prepare for attaching the wall mount bracket (bracket not shown in this step).

Section B: Assembling the Vacuum Cleaner

Step 1: Attach the floor nozzle to the wand.

Align the floor nozzle with the end of the wand and push until it clicks [click].

Step 2: Attach the wand to the main unit.

Align the wand with the connection point on the main unit and push until it clicks [click].

Alternative Assembly:

Step 1: Attach the main unit directly to the wand.

Align the main unit with the wand and push until it clicks [click].

Step 2: Connect the wand to the main unit.

Align the wand with the main unit and push until it clicks [click].

Section C: Charging the Battery

Step 1A: Connect the charger to the main unit.

Insert the charger connector into the charging port on the main unit.

Step 1B: Charge the battery.

Plug the charger into a wall socket. Place the main unit on a stable surface.

Step 2: Monitor charging.

The battery indicator will show the charging status. Initially, it shows 0% ?.

Step 3: Full charge.

The battery is fully charged when the indicator shows 100% ?. A full charge takes approximately 390 minutes (6.5 hours).

Section D: Operating the Vacuum Cleaner

Step 1: Select operating mode.

Choose between mode A or mode B by sliding the switch.

Step 1A: Turn the vacuum ON.

Press the ON button to start the vacuum cleaner. The device will operate in the selected mode.

Step 2: Activate BOOST mode.

To temporarily increase suction power, press the "BOOST" button. This provides maximum cleaning performance for demanding tasks.

Section E: Turning OFF and Emptying the Dustbin

Step 1: Turn the vacuum OFF.

Slide the switch to the OFF position to stop the vacuum cleaner.

Step 2: Empty the dustbin.

The dustbin has a MAX fill line. Remove the dustbin by following the indicated steps (arrow pointing to release mechanism). Empty the collected debris into a waste receptacle.

Section F: Cleaning and Maintenance

Filter Cleaning:

Step 1: Remove the filter from the dustbin.

Step 2: Rinse the filter with clean water ? and wipe it with a cloth.

Step 3: Allow the filter to air dry completely for at least 24 hours ☀️ ⏱️. Ensure it is fully dry before reinserting.

Attachment Assembly:

The diagrams illustrate how to connect various accessories and parts to the main unit or wand to create different cleaning tools. Follow the numbered steps to assemble the desired attachment.

For example, one sequence shows connecting a nozzle to the wand (1, 2), and another shows assembling a specific tool by connecting parts (3, 4, 5, 6) to form a complete unit (7, 8, 9).