Shark IQ 2-in-1 ROBOT

Robot Setup:

1. Set Up Dock + Landing Mat

   Remove protective film from robot and dock.

   Place dock in a spot with a strong Wi-Fi signal.

   Ensure at least 3 feet of clearance on the sides and front of the dock for optimal robot operation.

2. Attach Side Brush

   Note: Side brush design may vary.

   Attach the side brush to the underside of the robot by pressing it firmly into place.

3. Place Robot on Dock

   Robot will turn on when properly placed on dock.

   Blue LED light on the dock indicates robot is charging. ?

4. Scan the QR code to download the SharkClean® app.

   Complete your robot setup process in the app and learn about mopping mode.

   To get the best cleaning performance from your robot, we recommend downloading the latest version of the SharkClean® app.

   App Features:

   • Mapping
   • Scheduling
   • No-Go Zones
   • Carpet Zones
   • Spot Cleaning

Turn Page ➡️

What's Included:

• Robot Dock

  Charging dock for robot.

• Landing Mat

  Sits under the robot dock.

• Fluid Reservoir

  Enables mopping mode.

• Mopping Pad

  Reusable mopping pad for mopping mode.

Two Easy Steps If You're Stuck:

1. Visit: sharkclean.com/support

   • Owner's Guide
   • How-To Videos
   • Tips & Tricks
   • Troubleshooting
   • FAQs

2. For additional help, call 1-888-228-5531 for robot support.

Maximize Your Robot Experience:

Tips and tricks for getting the most out of your robot.

• To manually turn ON/OFF your robot, hold down the DOCK button for 6-8 seconds.
• Clear the area of cords and wires before each clean.
• Use mopping mode for daily maintenance and stuck-on messes.
• Only use Shark® VACMOP™ cleaning solution or water when mopping.
• Always place your robot on a level surface when performing maintenance.
• Clean brushroll and filter regularly.