Resistex Stairled Luminaire Installation Guide

Safety and Maintenance Instructions

Safety Notes

• Never work on the luminaire when it is live.
• Installation must be performed by a professional installer in compliance with relevant standards and regulations for electrical installations.
• Risk of electrostatic discharge (ESD Norm). Handle with necessary precautions.
• Please observe the notes and steps described in the mounting instructions.

Maintenance Instructions

• Do not use chemicals or abrasive products to clean the luminaire.
• Keep these instructions for dismantling or future maintenance.
• Additional information about RESISTEX luminaires is available on the website www.resistex-sa.com.
• RESISTEX cannot be held responsible for any misuse of the product.

Mounting / Installation Procedure

The following steps detail the installation process for the Resistex Stairled luminaire.

1. Step 1: Component Assembly

   The diagram shows the luminaire's main body and a separate diffuser ring. The diffuser ring is depicted being placed onto the main body.

2. Step 2: Prepare Mounting Surface

   Illustrates a mounting bracket being attached to a surface using screws (indicated by 'X4').

3. Step 3: Attach Luminaire Base

   Shows the luminaire base being mounted onto the bracket. Screws (indicated by 'X4') are used for this attachment.

4. Step 4: Electrical Connections (Initial)

   Depicts electrical wiring. Wires are shown connecting to terminals within the luminaire, with labels like 'L', 'N', and 'G' (Ground/Earth) visible on the terminal block.

5. Step 5: Secure Luminaire Body

   Shows the luminaire body being secured to the mounting bracket. The diagram indicates the use of screws (indicated by 'X4').

6. Step 6: Internal Wiring

   Illustrates the internal wiring connections. Wires are shown being inserted into a terminal block, with specific connections for Live (L), Neutral (N), and Earth (E).

7. Step 7: Terminal Block Identification

   A close-up of the terminal block, clearly labeled 'N', 'L', 'E', showing the correct connection points for the power supply.

8. Step 8: Final Luminaire Attachment

   Shows the luminaire being attached to the mounting bracket. Screws (indicated by 'X2') are used to secure it.

9. Step 9: Diffuser Placement

   The diffuser is shown being placed onto the luminaire. An arrow indicates the direction of placement.

10. Step 10: Secure Diffuser

    Illustrates securing the diffuser to the luminaire base using screws (indicated by 'X4').

11. Step 11: Completed Installation

    The luminaire is now fully installed and ready for use. The diagram shows the finished product mounted.