Fitting the Brackets
The brackets offer two methods of installation:
Top-Fixing
Use the front two holes in the top of the bracket to fix to the lintel (the 'ceiling' of the recess).
An illustration shows a bracket with two holes at the top. Arrows indicate screws passing through these holes into a horizontal surface representing a lintel.
Face-Fixing
Use two screws through the back plate to mount onto a facing surface (a wall or window frame).
An illustration shows a bracket with screws passing through its back plate onto a vertical surface representing a wall or window frame.
Bracket Spacing Note: The position of the outermost brackets should be at least 5cm away from the ends of the rail, with any other brackets evenly distributed across the width.
A diagram shows a horizontal rail with two brackets at the ends. Markers indicate a 5cm distance from each end of the rail to the center of the respective bracket.
Fitting the Shade
Step 1: Holding the rail at an angle, situate the T-shaped lip on the top of the cassette into the front lip of the bracket.
A side-view illustration depicts a bracket and a shade cassette. The cassette has a T-shaped lip at its front top edge. The illustration shows this lip being inserted into the front lip of the bracket.
Step 2: Twist the back of the cassette upwards until it snaps into place against the back lip of the bracket.
A subsequent illustration shows the back of the cassette being twisted upwards, with an arrow indicating the motion, until it clicks into place against the back lip of the bracket.
Remote BF-305A Programming Instructions
The remote control (Model BF-305A) allows programming of the motorized shades.
An illustration of the SelectBlinds Remote BF-305A shows buttons labeled: UP, STOP, DOWN, CHANNEL-, CHANNEL+, CONFIRM, and LIMIT. A battery compartment is also indicated.
Programming Steps:
Step 1: Adjust Working Mode
Set the switch on the motor to either 'BY' or 'BF' working mode.
- BY Mode: Short press the UP or DOWN button for jog rotation. Long press the UP or DOWN button for over 2 seconds for continuous rolling up or down.
- BF Mode: Short press the UP or DOWN button for continuous rolling up or down.
Step 2: Select Channel
Press the "CHANNEL+" or "CHANNEL-" buttons to cycle through channels until the LED for the desired channel is lit.
Step 3: Program Channel on Motor/Receiver
Ensure the motor or receiver is in its programming state, following its specific instructions.
Step 4: Confirm Programming
Within 6 seconds of the motor being in the programming state, press the "CONFIRM" button on the remote. The motor will jog, beep, or the receiver will beep to confirm successful programming.
Note: Group channels are automatically recorded on the motor once individual channels have been programmed.
according.to
