AVIOT TE-D01v True Wireless Earbuds User Manual

Using Earphones on One Side

To use a single earphone:

• Turn OFF the other earphone.
• Note: External sound capture mode can be used on the Left (L) side only.
• Note: Active Noise Cancellation (ANC) mode cannot be used on one side only.

Pairing

For detailed pairing instructions, please scan the provided QR code (in the original document).

1. Turn ON Bluetooth on your connected device.
2. Turn ON the earphones. The LED indicators will flash orange and white.
3. On your device, search for Bluetooth devices and connect to "AVIOT TE-D01v".

Reset Method (for Operation Failure)

If you encounter operation issues:

1. Delete the "AVIOT TE-D01v" Bluetooth setting from your connected device.
2. Place both earbuds in the charging case and keep the case open.
3. Press and hold the physical button on the back of the charging case for 10 seconds.
4. Upon successful reset, the LEDs on the case and earphones will blink white twice, indicating they have entered pairing mode.

Changing Pairing Device (for Multiple Devices)

If you have previously paired the earbuds with multiple devices:

• To switch to a different device, you may need to perform a specific action, such as a double-press on the earphone's touch sensor. The LED flashing speed can indicate the pairing status.
• Refer to the "Pairing" section (step 3) to connect to a new device.

Power ON/OFF

When switching with the charging case:

• To turn ON: Place the earphones into the charging case. Ensure the orange LED is lit before closing the case.
• To turn OFF: Remove the earphones from the charging case. The power will automatically switch OFF after 5 minutes of inactivity.

When switching with the earphone itself:

• Power ON: Press and hold the touch sensor on either earphone for approximately 3 seconds. The LED will turn white.
• Power OFF: Press and hold the touch sensor on either earphone for approximately 4.5 seconds. The LED will turn orange.

Special Modes

Active Noise Cancellation (ANC) Mode:

To activate ANC mode, press and hold the touch sensor after hearing the voice guidance. Release your finger immediately after the sound effect plays.

Ambient Microphone Mode:

Press and hold the touch sensor on the Left (L) earphone for 1.5 seconds to activate Ambient Microphone Mode.

Charging

The earbuds can be charged using the included USB Type-C cable.

To initiate pairing mode from the charging case: Place the earbuds in the charging case, ensure the orange LED is on, and press the physical button on the back of the case twice. After the battery indicator flashes, remove the earbuds from the case.

Included Accessories

• Ear caps in sizes S, M, and L.
• USB Type-C cable.

FCC Compliance Information

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.