DOCKSTA

Tools Required

• Hammer ?
• Wrench ?

Parts List

• 6x Screw (Part 100181)
• 4x Screw (Part 121212)
• 6x Screw (Part 100850)
• 1x Nut (Part 100778)
• 1x Washer (Part 110737)
• 8x Bracket/Connector (Part 10042799)
• 1x Allen Key (Part 108490)

Important Information

• Assembly is recommended for two people. [two-people-icon]
• Protect your floor during assembly by using the packaging or a rug. [rug-icon]
• Ensure all parts are present before beginning assembly. [check-icon]
• If you encounter any difficulties, please refer to IKEA customer support. [phone-icon]

Step 1: Attach Brackets to Tabletop Base

Place the tabletop upside down on a protected surface. Identify the pre-drilled holes on the underside of the tabletop base.

Take 8 Bracket/Connector pieces (Part 10042799). Align each bracket with the designated holes.

Insert 8 screws (Part 100181) through the brackets and into the tabletop base. Gently tap the screws into place with a hammer ? before fully tightening them using the provided Allen key (Part 108490).

Step 2: Attach Central Column to Tabletop Base

Two people are shown holding the central column and the tabletop base.

Align the central column with the assembled base. The column has a flange designed to fit into the bracket assembly.

Insert 4 screws (Part 121212) through the central column's flange and into the brackets attached in Step 1. Tighten these screws using the Allen key (Part 108490).

Step 3: Connect Base to Column

The diagram shows the central column being inserted into the table's base, with an arrow indicating downward motion.

Ensure the column is correctly oriented. A symbol showing a cross ❌ over an arrow indicates the incorrect way to insert it.

Push the central column firmly into the base until it is securely seated.

Step 4: Attach Base Cover

Take the decorative base cover. An arrow shows it being slid down over the central column.

Slide the decorative base cover down over the central column until it rests on the table base.

Step 5: Attach Column Cover

Take the decorative column cover. An arrow shows it being slid down over the central column.

Slide the decorative column cover down over the central column until it meets the base cover.

Step 6: Secure Column Cover

The diagram shows hands securing the column cover to the central column using internal clips or mechanisms.

Press down on the column cover to engage any locking mechanisms, securing it to the central column.

Step 7: Attach Tabletop to Column

The diagram shows the tabletop being placed onto the assembled underframe. Hands are shown aligning the tabletop with the column.

Align the underside of the tabletop with the top of the central column assembly.

Press down firmly on the tabletop to secure it to the central column.

Step 8: Final Tightening (Base)

The diagram shows a close-up of the underside of the table base, where the central column connects.

Use a wrench ? to tighten the central nut (Part 100778) and washer (Part 110737) at the base of the column, securing it to the tabletop base.

Step 9: Turn Table Upright

Two people are shown carefully turning the assembled table upright.

Carefully turn the assembled table upright.

Step 10: Secure Tabletop to Column

The diagram shows the Allen key (Part 108490) being used to tighten 6x screws (Part 100850) from underneath the tabletop into the central column.

From the underside of the tabletop, insert and tighten 6x screws (Part 100850) using the Allen key (Part 108490) to firmly attach the tabletop to the central column.

Step 11: Final Placement

Two people are shown positioning the completed table.

Place the assembled DOCKSTA table in its desired location.