How do I unpair, then pair my ZWave (EVC200) Bulldog Controller?

Device Description: A small, white, rectangular device featuring the 'EcoNet Controls' logo and 'Smart Home Valve Robot' text. It is labeled with 'Model: EVC200', '12VDC/1A', and 'ZWAVE PLUS' indicators. 'CE' and 'FC' logos are also present. A single, prominent red circular button is located on the front.

Difficulty:

Easy

Example:

The device LED is solid green, indicating it has been paired with a controller. Is there a way to factory reset the device then pair it to a new controller?

Unpairing:

• You should exclude the Bulldog Valve Controller in the ZWave hub/controller's software by following the steps for your specific ZWave hub/controller for excluding the device and then pressing the EVC200 button 3-5 times quickly.
• If this isn't possible, you can perform a system reset on your ZWave bulldog controller by holding down the controller button for over 10 seconds. You will see the LED quickly blip when done.

Pairing:

• Set your ZWave Controller to scan for ZWave devices or specify the EcoNet Valve Robot if this option is present.
• Set your controller to pair to your new hub by pressing the button on the controller repeatedly as fast as you can 3-5 times. This can take a minute depending on the ZWave Controller.