SHARP ES-W110DS ES-W100DS Full-Automatic Washing Machine

Introduction

Thank you for purchasing our product. Please read this manual carefully before use. Please read "Safety Precautions" carefully before use. Please keep this manual in a safe place. Our product is specially designed for household use only.

Safety Precautions

⚠️ WARNING

• ? Do not allow children to play with or look around the washing / spin drying tub, in case of injury.
• ? Do not wash clothing stained with harmful diluting agents such as gasoline (⛽), kerosene, and so on, in the washing / spin drying tub.
• ? Before the washing / spin drying tub completely stops, do not touch the clothing being washed. Even if the tub is running at low speed, your hand may get wrapped up and injured. Special attention should be paid to children. ✋
• ? Do not use power supply other than AC220-240V, 50Hz, so as to avoid malfunction, damage, and fire.
• ? Except professional repair-men, do not modify the machine. Please do not disassemble (?) and repair the machine without permission, so as to avoid fire, electric shock, getting hurt, or malfunctions of the machine.
• ? Do not place the machine at high-humidity places such as bathrooms, locations where wind and rain may get in, and so on. Otherwise, electric shock, fire, malfunctions, and distortion may take place. ?
• ? Do not change the original state of the power cable. Any artificial damage to the power cable could cause electric shock, electric leakage, or other malfunctions.
• ? Do not use damaged power cable, plug, and loose plug socket, so as to avoid short circuit, electric shock, fire, and other accidents.
• ? Do not use water to wash components of the machine, so as to avoid short circuit and electric shock. ?
• ❗ Use plug socket above 13A separately. A loose plug socket or the action of sharing a plug socket with other apparatus may start a fire due to heat.
• ? Do not approach any fire source to a plastic component, which has the risk of starting a fire. ?
• ❗ While cleaning the machine body, the plug should be pulled out first. Do not plug or pull the plug with a wet hand or wet cloth, so as to avoid electric shock. ?
• ❗ Clean the dust on the plug and plug socket to avoid fire.

CAUTION

• To avoid danger, if the soft power cable is damaged, it must be replaced by the manufacturer or its maintenance department or similar dedicated personnel.
• If powder detergent or liquid detergent adheres to a plastic component such as the top cover, wipe it away immediately, otherwise it may damage the plastic component.
• Each time washing is finished, clean the lint filter box. Otherwise, it may not have effect to trap lint.

Name of Each Component

This section describes the main parts of the washing machine.

Machine body

• Top cover: The lid of the washing machine.
• Lint filter box: Located inside the tub, collects lint.
• Control panel: Interface for operating the machine.
• Pulsator: The part that agitates the clothes.
• Cabinet: The outer casing of the washing machine.
• Water inlet hose connecting port: Where the water hose connects.
• Drain hose: For expelling water from the machine.
• Power cable: Connects the machine to the electrical outlet.
• Adjustable foot: For leveling the machine.

List of Accessories

* Bottom Cover and Screw are applied by Service staff.

Key Points of Washing

Pay more attention to the following situations:

• Before washing, please remove sludge and sand on clothing first.
• For very dirty parts of the clothes, you can smear some liquid detergent on them and rub them in advance.
• For clothing that are easy to pill, please turn it inside out first and then wash it.
• Large clothing and clothing that are easy to float should be put into the washing tub first. Please put large clothing and clothing that are easy to float (chemical fibers etc.) at the bottom. This is beneficial to the good rotation of clothing.

To avoid damage to tub, pulsator...

• Please take out coin, hair clip, curtain hook, and other metal.
• Wrap up buttons and zipper and put them on the inner side.
• Put bra etc. in washing mesh bag.

To avoid damage to clothing, winding of clothing...

• Belts on apron and so on must be knotted; zippers must be zipped.
• Thin or easily damaged clothing must be washed in a washing mesh bag.
• Metal decorations (zippers etc.) on the clothing in a washing mesh bag must be checked.

For better washing...

• Please check the washing mark. ?
• Wash clothing easy to fade separately.
• For towels and other clothing easy to produce lint, please wash them separately or use a washing mesh bag. ?

To protect the environment

• Avoid the waste of water, detergent ?, and electricity.
• During washing, wash clothing together.
• Put in a proper amount of detergent according to the fouling situation.
• Reuse detergent liquid. ♻️

While using a washing mesh bag, put in as little clothing as possible. Too much clothing will decrease the performance during rinsing and spin drying or cause the offset of clothing during spin drying.

Instruction on Control Panel Functions

The control panel allows you to select courses, set options, and monitor the washing process.

Control Panel / Display Overview:

The display shows the selected course, remaining time, water level, and error codes.

Buttons:

• POWER ON/OFF: Press to turn the machine on or off.
• START/PAUSE: Press to start or pause the selected course.
• COURSE: Selects the washing program (e.g., NORMAL, JEANS, SPEEDY, DELICATE, BLANKET, BABYCARE, TUB CLEAN, ECO).
• WASH: Sets washing time.
• RINSE: Sets rinsing cycles.
• SPIN: Sets spin drying time.
• AIR DRY: Reduces drying time by circulating air.
• WATER LEVEL: Selects the appropriate water level (8 steps).
• RESERVE: Sets a delayed start time (1-24 hours).
• SOAK: Adds a soaking phase to most courses (5 min - 24 hrs).
• FRAGRANCE: Enhances softener efficacy by adding a soaking time with softener.

Special Functions:

• CHILD LOCK: Hold FRAGRANCE for 3 seconds to activate/deactivate. Prevents accidental operation. ?
• AUTO CLEAN: Hold WATER LEVEL for 3 seconds to run a self-cleaning cycle for the tub. ?

Notes:

• If the machine is energized but not started, the power supply turns off automatically after 5 minutes.
• If no key is pressed after START/PAUSE is pressed during operation, the power supply turns off automatically after 10 minutes.
• The machine generates a beep when it finishes a course or supplies water.
• The nominated program *ECO is recommended for normally soiled loads equal to the rated capacity.

Things to Know Before Washing

• Select the course depending on the type of clothing or degree of dirt on clothing.
• After pressing START/PAUSE key once, you cannot change the course. To change the course, turn off the power and select the desired course again.
• Blinking display indicates the step in operation; lighting display indicates the course selected.
• When the motor gets hot beyond a safe limit, it will fail-safe and stop operation. Do not use more than 3 continuous runs.

Caution:

• When the motor fails-safe, it stops operation. After cooling down, it can be used normally.

Instruction on Washing Courses

Automatic Sensing Function ⚙️

The washing machine selects the wash method (water level, water current, operation time) by sensing the weight of clothing. This function does not work if you manually select water level or change the course. Ensure there is no or very little water in the tub when using this function.

To use: Press POWER ON/OFF, then COURSE key and select NORMAL course, then press START/PAUSE.

Caution: If you select water level manually in the normal course, the automatic sensing function does not work.

AIR DRY ?

This course reduces drying time by circulating air. Spin-drying with high-speed takes air into the inner tub from the top lid holes.

To use: Press POWER ON/OFF, then AIR DRY key (light turns on), then press START/PAUSE. Drying time can be set to 30min, 60min, 90min, or 0 (default).

The machine generates a beep and turns off when it finishes the course.

Self-Decided Washing Course

This allows you to select specific processes like rinsing and spinning.

Example: Only rinsing and spinning

1. Put the clothes in the tub, and press POWER ON/OFF key.
2. Select the course as necessary.
3. Select the necessary processes (e.g., WASH, RINSE, SPIN, WATER LEVEL).
4. Before starting rinsing, please select [Water level].

Specific Cases:

• Only spinning: Select SPIN.
• Only draining: Select DRAIN. (Keep the top cover open. Machine displays [E2] when finished.)
• Reuse of detergent liquid: If detergent liquid is left in the tub.

Put in detergent as required, and close the top cover properly. Press START/PAUSE key.

Additional Operating Procedures

RESERVE ⏰

Set a desired reservation time (1-24 hours). The displayed time indicates when the operation will finish.

To use: Press POWER ON/OFF, select COURSE, press RESERVE and set time, then press START/PAUSE. The time setting counts down.

SOAK ?

This course can be added to most courses (except TUB CLEAN). It adds a soaking phase.

To use: Press POWER ON/OFF, select SOAK and set soaking time (5 min - 24 hrs), then press START/PAUSE.

FRAGRANCE ?

Enhances softener efficacy by adding a soaking time with softener at the beginning of the final rinse.

CHILD LOCK ?

Hold FRAGRANCE key for 3 seconds to activate/deactivate. If the top cover is opened after water supply starts, an error tone sounds. If the cover remains open for 30 seconds, water drains automatically. Only POWER ON/OFF and START/PAUSE keys are operational in this mode.

AUTO CLEAN ?

Hold WATER LEVEL key for 3 seconds to activate. This cleans the washing/spin drying tub and the back of the pulsator with clean water during the final spin.

Maintenance

Appropriate maintenance helps extend the life of your washing machine.

TUB CLEAN ?

For cleaning the washing / spin drying tub.

Caution: Do not put clothing in the tub during this course.

1. Press POWER ON/OFF with the top cover closed.
2. Press COURSE key and select TUB CLEAN course.
3. Press WASH key and select washing time. Press WATER LEVEL key and select water level.
4. Press START/PAUSE key. The machine starts supplying water and displays remaining time. A beep sounds when water supply is finished.
5. Press START/PAUSE key to pause. Add washing machine cleaner for the tub.
6. Close the top cover and press START/PAUSE key to restart.

Water Inlet Hose Filter Net

The filter net can easily get blocked with prolonged use. Clean it as follows:

1. Turn off the faucet.
2. Turn on the power and press the WATER LEVEL key.
3. Confirm the top cover is closed. Make sure water in the hose has been drained.
4. Dismantle the water inlet hose. Twist the connecting part, not the hose. Wait about 10 minutes, then turn off the power.
5. Clean the filter net. Remove the filter net and clean it.

Lint Filter Box

Clean each time after washing.

1. Detach the lint filter box from the washing tub.
2. Clean the lint filter box and the tub side.
3. Attach the lint filter box back onto the washing tub, pointing downwards.

Washing / Spin Drying Tub

• Each time after washing, turn off the faucet and power. (Dismantle water inlet hose if necessary.)
• Wipe away water in the tub as soon as possible after washing.
• Pull out the plug from the socket during maintenance.
• Hanging the power cord and drain hose is recommended.
• Open the top cover for about 1 hour after wiping away water and dirt to allow ventilation.
• Do not use solvents like alcohol or cleanser, as they may damage the tub surface.

Common Non-Fault Phenomenon

These phenomena may not indicate a fault. Please check these points before sending the machine for repair.

Inspection of a washing machine that has been used for many years.

Check:

• Doesn't operate sometimes.
• "CHILD LOCK" doesn't work during operation.
• Water leakage (water hose, spinning tub, tap connection).
• Burning smell.
• Abnormal sound or vibration during operation.
• Hand feels numb while touching the machine.
• Power cable or plug is unusually hot.

Stop using the machine: To avoid faults or accidents, pull out the plug. Entrust the maintenance department for check and repair.

Specifications