OKIN REFINED System Instruction - RF401B

Instruction of RF401B

Figure 1 shows the buttons on the remote control.

Button Descriptions:

• 1: ZERO G: Pressing this button moves the actuator to the ZERO G position. The movement stops when any button is clicked during operation. Pressing and holding the ZG button for 5 seconds will record the current position as the ZG position, indicated by a flashing timer LED on the remote. When moving to memory positions, the head and foot actuators move first, followed by the tilt and lumbar actuators.
• 2: HEAD UP: Pressing and holding the HEAD UP button moves the head actuator outwards. The movement stops when the button is released.
• 3: FOOT UP: Pressing and holding the FOOT UP button moves the foot actuator outwards. The movement stops when the button is released.
• 4: HEAD DOWN: Pressing and holding the HEAD DOWN button moves the head actuator inwards. The movement stops when the button is released.
• 5: FOOT DOWN: Pressing and holding the FOOT DOWN button moves the foot actuator inwards. The movement stops when the button is released. When moving to the flat position, the lumbar and tilt actuators move first, followed by the head and foot actuators after a 500ms delay.
• 6: TV/PC: Pressing this button moves the actuators to the TV/PC position. The movement stops when any button is clicked during operation. Pressing and holding the TV/PC button for 5 seconds will record the current position as the TV/PC position, indicated by a flashing timer LED on the remote. When moving to memory positions, the head and foot actuators move first, followed by the tilt and lumbar actuators.
• 7: LOUNGE: Pressing this button moves the actuators to the LOUNGE position. The movement stops when any button is clicked during operation. Pressing and holding the LOUNGE button for 5 seconds will record the current position as the LOUNGE position, indicated by a flashing timer LED on the remote. When moving to memory positions, the head and foot actuators move first, followed by the tilt and lumbar actuators.
• 8: FLAT: Pressing the FLAT button flattens the bed. The movement stops when any button is clicked during the process of going flat.

FCC Warning

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

ISED RSS Warning:

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:

• (1) this device may not cause interference, and
• (2) this device must accept any interference, including interference that may cause undesired operation of the device.

French Translation:

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts de licence. L'exploitation est autorisée aux deux conditions suivantes :

• (1) l'appareil ne doit pas produire de brouillage, et
• (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.