Important Safety Information
Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.
STOP ✋
For assistance, contact Baby Trend Customer Service at 1-800-328-7363 between the hours of 8:00 A.M. and 4:30 P.M. Pacific Standard Time. Please have your model number and manufacturing date available when you call. This information can be found on a small sticker under the seat.
Warnings
WARNING: Failure to follow these warnings and the instructions could result in serious injury or death.
WARNING: Prevent serious injury or death from falls or sliding out. Always secure child in the restraint. NEVER leave child unattended.
WARNING: The child should be secured in the high chair at all times by the restraining system, either in the reclining, semi-reclining or upright position. The tray is not designed to hold the child in the chair. It is recommended that the high chair be used in the upright position only by children capable of sitting upright unassisted. See page 18 for instructions on proper use of restraint system.
- Other accessory items may change the balance of the high chair and cause hazardous unstable conditions; use approved Baby Trend toys.
- Be certain the high chair is fully erect and latched in the open position before allowing the child near the high chair.
- Use of the high chair with a child weighing more than 40 pounds will cause excessive wear and stress on high chair.
- The maximum weight that can be carried in the basket is 5 lb. Excessive weight may cause a hazardous unstable condition to exist.
- NEVER allow your high chair to be used as a toy.
- NEVER use this product if there are any loose or missing fasteners, loose joints, broken parts, or torn mesh/fabric. Check before assembly and periodically during use. Contact Baby Trend Customer Service at 1-800-328-7363 for replacement parts, repair or instructions. NEVER substitute parts.
If you experience any difficulty with the use of our product or have a question regarding these instructions, please contact our Customer Service Department at 1-800-328-7363 between the hours of 8:00 a.m. and 4:30 p.m. (PST). Please do not return the product to the store as once it is returned it cannot be re-sold and the materials and energy used to make it are wasted.
Parts List
This model may not include some features shown below. Check that you have all the parts for this model before assembling the high chair.
Diagram Description: A visual representation of all the parts included with the high chair, each labeled with a number.
- 1. Seat Back: The main support for the child's back.
- 2. Height Brackets: Components used to adjust the chair's height.
- 3. Tray Insert: A removable piece for the tray.
- 4. Tray: The main feeding tray.
- 5. Upper Frame Assemblies: The main structural components of the upper part of the chair.
- 6. Seat Back Hinge Rod: Connects the seat back to the seat base.
- 7. Seat Base: The foundation of the seat.
- 8. Crotch Retainer: A safety strap component.
- 9. Legs: The supports for the chair.
- 10. Screws: Fasteners (4 x 3.5mm x 10mm).
- 11. Footrest: Support for the child's feet.
- 12. Casters: Wheels for mobility (4 included).
- 13. Seat Pad: Cushioning for the seat.
- 14. Seat Insert (optional): Additional padding or support.
- 15. Basket (optional): Storage compartment.
Assembly Instructions
IMPORTANT! To ensure safe operation of your product, please follow these instructions carefully. Please keep these instructions for future reference.
IMPORTANT! Before assembly and each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges. NEVER use if any parts are missing or broken.
IMPORTANT! Adult assembly is required.
IMPORTANT! Always check that the high chair is locked in the open position before using.
Step 1: Assemble Seat
Place the Seat Base on a flat surface.
Step 2: Attach Seat Back to Seat Base
Join the Seat Back to the Seat Base using the Seat Back Hinge Rod. Insert the rod from right to left.
Step 3: Attach Height Brackets
Slide the left and right sides' Height Bracket onto the Seat Base and snap them into place.
Step 4: Attach Footrest
Slide the Footrest onto the Seat Base and snap it into place.
Step 5 & 6: Attach Upper Frame Assemblies
Insert the front tube of the right side Upper Frame Assembly into the corresponding Height Bracket. Squeeze the Red Release Handle and push the tube through the bracket until it locks in the highest position. Repeat for the left side.
Step 7 & 8: Insert Legs
Insert the Legs into the ends of the front tubes of both Upper Frame Assemblies. Ensure push buttons align with holes and are engaged. Insert the rear legs into the rear tubes.
Step 9: Attach Casters
Attach each of the Casters to the high chair feet. Ensure all four Casters are securely fastened.
Step 10: Attach Crotch Retainer
Flip over the Tray. Orient the molded plastic housing with the slot facing the front of the Tray. Insert the 4 screws (3.5mm X 10mm) and tighten, but do not over-tighten.
Step 11: Attach Seat Pad
Loop the flap on the back of the pad over the top of the Seat Back. Connect the Seat Pad to the Seat Back using the two Elastic Loops, fitting them over the Attachment Tabs near the top harness slots.
Step 12: Connect Seat Pad Bottom
Attach the bottom of the Seat Pad to the Seat Base using the two Elastic loops at the rear of the pad. These fit over the Attachment Tabs on the Seat Base.
Step 13: Set Seat Insert
Place the Seat Insert onto the Seat Pad.
Step 14: Thread Harness Straps
Thread the non-buckle end of the Harness Straps (Harness Attachment Tabs) through the provided slots in the Seat Fabric, Seat Insert, Seat Back, and Seat Base. Rotate the tabs 90 degrees to ensure they are firmly in place.
To Remove Seat Pad:
Reverse the assembly steps.
Open High Chair:
Push the legs apart until fully open and locked. Push downward on the fold levers (left and right) to ensure the frame is locked open.
Operation
Attaching and Operating the Tray
To attach the Tray, align the grooves on the bottom of the tray with the armrests. Squeeze the Tray's release handle and slide the tray onto the armrests. The tray has a 3-position adjustment. To adjust, squeeze the release handle and reposition the tray. Ensure the tray is securely locked.
Attaching Tray Insert
The dishwasher-safe food Tray Insert snaps onto the High Chair Tray and is held by tabs. Ensure it snaps into place to prevent the child from removing it. To remove, unsnap the tabs.
Reclining Seat
Squeeze the recline lever on the back of the seat and adjust to the preferred recline or upright position. Be careful not to catch the child's arms, hands, or legs.
Using the Safety Belt
Place the crotch strap between your child's legs. Insert the Harness Buckles into the Center Clasp with the Red Button. Adjust waist straps for comfort and safety by sliding buckles. Ensure straps fit snugly.
Releasing Safety Belt
Push the Red Button on the Center Clasp; the buckles will pop free.
Adjusting Seat Height
WARNING: Do not adjust seat height with child in seat. Adjust seat height before placing your child in the high chair.
Squeeze both left and right levers of the Height Adjustment Bracket and adjust to the ideal position. Always check that the bracket is level and both sides are locked before placing the child.
Folding High Chair
The high chair can be folded in any height position. It is most compact in the lowest position.
Place seat in the desired height position and Seat Back in the most upright position.
Squeeze the tray release handle and slide the tray out.
Hang the tray on the hooks located on the back of the rear leg.
Pull upward on the release levers (on the sides of the frame) and push the rear legs towards the front legs until folded. The chair is now ready to put away. DO NOT allow your child to play around a folded high chair as it may fall.
Unfolding High Chair
Push the legs apart until fully open and locked. Push downward on the fold levers (left and right) to ensure the frame is locked.
Maintenance and Care
WARNING: Harness Straps and Basket are NOT washable.
Tray Insert:
Dishwasher safe up to 160°F. Do not use scouring pads. Clean with mild dish soap.
High Chair/Tray:
Clean after each use with mild household dish soap. Use a soft bristle brush, sponge, or cloth. Do not submerge in water. Surface clean only.
Seat Pad:
Refer to care label on the seat pad for specific instructions.
Non-Washable Seat Pad: Use sponge/cloth with mild detergent. DO NOT MACHINE WASH.
Washable Seat Pad: Machine wash COLD DELICATE CYCLE with non-chlorine detergent. DO NOT USE BLEACH. HANG DRY. DO NOT MACHINE DRY.
Basket:
Some models have a basket underneath the seat. To remove, release the four snaps. To attach, feed snap strips around basket slots and press snaps firmly.
