MANUAL
For Toyota Corolla 2009-2013 / C7278
Central Control Disassembly and Operation
Post-installation rendering
⚙️??
TOOLS REQUIRED FOR DISASSEMBLY
- Wire
- Installation tools
Disassembly
Use a pry bar to remove the decorative side trims of the air conditioning control panel, then unscrew the screws on both sides of the seatbelt warning panel. Pry open the storage compartment, remove the seatbelt warning panel, and disconnect the wires within it.
Image sequence shows a plastic pry tool being used to remove trim panels, unscrewing screws on a warning panel, opening a storage compartment, and disconnecting wire harnesses.
Pry open the decorative side trims on both sides of the radio, remove the air conditioning control panel, and then take out the outer frame of the radio along with the air conditioning vents.
Image sequence shows prying decorative side trims, removing the central air conditioning control panel, and then carefully removing the radio's outer frame along with the air conditioning vents.
Unscrew the four screws on both sides of the original radio, remove the radio, and unplug the wires connected to the original vehicle.
Image sequence shows unscrewing four screws securing the original radio, pulling the radio unit out, and disconnecting the electrical connectors.
PROPOSE
Before starting the replacement job, you should prepare tools such as a plastic pry tool and a screwdriver, and make sure the car's power is cut off during the installation.
Installation
(If the wiring harness does not match, please contact customer service to request the correct wiring harness)
Connect the wires from the original vehicle to the new radio, then install the radio and the new frame into the designated position. Reattach the air conditioning vents and the air conditioning control panel to their original positions.
Image sequence shows connecting the new radio's wiring harness to the vehicle's harness, inserting the new radio and its frame into the dashboard, and reattaching the air conditioning vents and control panel.
Connect the wires from the seatbelt warning panel to the original vehicle, reinstall it into the car, and place the storage compartment back into its corresponding position. Finally, tighten the screws on both sides of the seatbelt warning panel.
Image sequence shows connecting the seatbelt warning panel wires, reinstalling the panel into the car, positioning the storage compartment, and tightening screws.
Reinstall the decorative side trims on both sides of the radio and the air conditioning control panel back into the original positions in the car. The installation of the new radio is now complete.
Image sequence shows reattaching the decorative side trims around the radio and air conditioning control panel, completing the installation.
COMPARATION
Effect of Installation
Side-by-side images illustrating the 'before' and 'after' appearance of the car's central console after the new stereo installation.
GENTLE REMINDERS
Due to the complexity of the product structure, you may encounter some problems during installation. If you still have any questions about the installation after reading this manual, you can contact us and we will respond to you within 24 hours. Don't worry; we will do our best to solve the problem for you until you are satisfied.
After-sales email: cheyang728@gmail.com
WARN FCC WARNING
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) This device must accept any interference received, including interference that may cause undesired operation.
