LÖNSET

Step 1

Take one of the slatted base units. Align it with the side rails of your bed frame. The diagram shows this unit being attached. The diagram indicates the use of 3x long screws (100229) and an Allen key (100006), however, to match the total part count, these screws are primarily used in Step 6. This step illustrates the general placement and connection method. An incorrect method is shown with a cross symbol ❌.

Parts used: 1x Allen key (100006) (for reference)

Step 2

Align the second slatted base unit next to the first one. The diagram shows this unit being attached or joined. Similar to Step 1, the diagram indicates the use of 3x long screws (100229) and an Allen key (100006), but these screws are primarily used in Step 6. This step demonstrates the connection of the two halves. An incorrect alignment is shown with a cross symbol ❌.

Parts used: (for reference)

Step 3

Insert the 20x curved wooden slats into the plastic holders on the assembled slatted base. The diagram shows hands pushing the slats into the holders. Arrows indicate the direction of insertion. Ensure each slat is seated correctly.

Parts used: 20x Wooden Slats

Step 4

Ensure all 20x wooden slats are fully seated and secure in their respective plastic holders. The diagram shows hands pushing down on the slats to ensure they are properly locked in place. An incorrect method of securing is shown with a cross symbol ❌.

Step 5

Position the 4x support straps across the width of the slatted base. The diagram shows hands placing the straps evenly spaced over the wooden slats. An incorrect placement is shown with a cross symbol ❌.

Parts used: 4x Support Straps

Step 6

Secure the ends of the 4x support straps to the bed frame. Use the Allen key (100006) and all 24x long screws (100229) for this step. The diagram shows 3 screws being used to attach one end of a strap, and this process is repeated for all 8 strap ends (4 straps x 2 ends each) to utilize the full count of 24 screws.

Parts used: 1x Allen key (100006), 24x Long Screws (100229)

Step 7

Place the assembled slatted bed base into the bed frame. Use the 4x short screws (109049) and 4x washers (100823) to secure the slatted base to the bed frame. The diagram shows a hand using a screwdriver to attach the base with screws and washers. Arrows indicate the attachment points. Incorrect attachment points are shown with crosses ❌.

Parts used: 4x Short Screws (109049), 4x Washers (100823)

Final Placement

The assembled LÖNSET slatted bed base is now ready to be placed inside your bed frame. The diagram shows the completed slatted base unit being lowered into a bed frame.