Page Turning Cat Remote

Page Turner

Charge Input / USB-C Port

Indicator:

• White Screen - Charging (Page Turner)

How to Use:

• Hold the power button to turn the page turner on, the white LED on the screen will light up.
• Clip Page Turner to your e-reader, making sure the cat face is facing towards you when reading the e-reader and it is on the right side of the screen.
• To use the automatic page turner, do not turn the remote on.
• Adjust the amount of time you would like between page turns; the screen will display this in seconds. Press the power button to activate the automatic page turn; the page will turn when the set seconds are reached; the max time is 99 seconds.

Remote

Charge Input / USB-C Port

Indicator:

• Flashing Red - Charging (Remote Control)
• No Light - Fully Charged

How to Use:

• Hold the remote control for 3 seconds to turn it on; the page turner and the remote will automatically pair. The remote will flash blue and the screen on the page turner will turn off once paired.
• Use the remote to turn pages by clicking buttons (left, right, up, and down).

Product Description and Operation

The Page Turning Cat Remote is designed for seamless page turning on e-readers and touch screen devices. It consists of a Page Turner unit and a Remote Control unit.

Page Turner Controls:

• Hold: Power on/off
• Hold: Page number +
• Press: Page number-
• Setting: Automatic page turning seconds

Remote Controls:

• Hold: Power on/off
• Press: Left, right, up, down to turn the page

The automatic page turning feature allows you to set a delay between page turns. After setting the desired seconds (up to 99), press the power button on the Page Turner to activate this mode.

Charging

A full charge for the Page Turner or the remote requires approximately 2 hours. Use the provided USB-C cable to connect the devices to a USB power supply (at least DC 5V 1A). A UL-compliant power supply is recommended.

Charging Indicators:

• Page Turner: The screen will turn white while charging and turn off when charging is complete.
• Remote: The indicator light will turn red while charging and turn off when charging is complete.

Troubleshooting

• If the page turner and remote are not working correctly, try holding the power on/off button to reset them.
• If the devices won't turn on, recharge the battery and try again.
• Ensure the supply used for charging is working, provides 5V 1A, and is not damaged.

Safety Information

• Do not modify or repair this device.
• Avoid using the device in high temperatures or extreme weather conditions.
• Clean the device using a soft, dry cloth only. Do not use chemical detergents.

What's Included

• Page Turner
• Remote Control
• USB-A to USB-C Charging Cable

Technical Specifications and Compliance

Page Turner

• FCC ID: 2A023-KPTR
• Model: KPTR
• USB-C Input: 5V - 1A

Remote

• FCC ID: 2A023-KPTRI
• Model: KPTRI
• USB-C Input: 5V 1A
• Made in China

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Contact and Support

For support and repair information, please contact the original manufacturer:

gemsfindyours.com

7157 Shady Oak RD, Eden Prairie, MN 55344

Distributed by Chug, Inc.

For qualified repair specialists requesting repair information and parts, please contact customersupport@gemsfindyours.com.