Page Turning Remote
Universal Touch Remote for E-readers and Touch Screen Devices
Product Components
The Page Turning Remote package includes:
- Page Turner
- Remote Control
- USB-A to USB-C Charging Cable
Remote Description:
- Charge Input / USB-C Port: For charging the remote.
- Indicator: Shows charging status.
- Press any key: Turns the page.
- Hold: Power button to turn the remote on/off.
Page Turner Description:
- Indicator: Shows charging status.
- Hold: Power button to turn the page turner on/off.
- Charge Input / USB-C Port: For charging the page turner.
- The silicone pad (sensor clip) should touch the front of the e-reader screen.
How to Use
- Hold the power button to turn the page turner on; the indicator will turn solid red.
- Press any button on the remote control to turn it on. The remote and page turner will automatically connect. The page turner flashes blue when the connection is successful.
- Clip the page turner to your e-reader, ensuring the clip faces you and is on the right side of the screen.
- Use the remote buttons to turn pages.
- Note: If the remote control is idle for over 10 minutes, the page turner enters standby mode to save power. Press the page turner's power button to wake it up. The page turner will flash a blue light, then press the remote control to use it.
Troubleshooting
- If the page turner and remote are not working correctly, hold the power button of the page turner on/off to reset.
- If the page turner and remote won't turn on, recharge the battery and try again.
- If the page turner and remote won't charge, ensure the power supply is working (5V 1A) and not damaged.
- Keep the silicone pad (sensor clip) of the page turner trigger area clean.
- When using the page turner, ensure the total thickness of the e-reader and its cover does not exceed 13.5mm (0.54 inches).
- If the page turner won't turn pages, try repositioning it on the screen to find a suitable trigger point.
Safety
- Do not modify or repair this device.
- Do not use in high temperatures or extreme weather.
- Do not use chemical detergents to clean your device; use a soft, dry cloth.
SAVE THESE INSTRUCTIONS
Indicator and Charging
Indicator Status (Remote):
- One Light: 25% charged
- Two Lights: 50% charged
- Three Lights: 75% charged
- Four Lights: 100% charged
Indicator Status (Page Turner):
- Flashing Red: Low Battery / Charging
- No Light: Fully Charged
Charging Instructions:
- A full charge for the page turner or remote takes approximately 2 hours.
- Use the provided USB-C cable. Connect the USB-C end to the page turner or remote and the USB-A end to a USB power supply with at least DC 5V 1A output. Use only UL-compliant power supplies.
- Page Turner: The indicator light flashes red while charging and turns off when charging is complete.
- Remote: The indicator light flashes red or blue while charging and turns solid blue when charging is complete.
Technical Details
- Page Turner Model: KPTR2
- USB-C Input: 5V_1A
- Remote Model: KPTR2
- Remote FCC ID: 2A023-KPTR2
- Remote USB-C Input: 5V_1A
- Made in China
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirements and can be used in portable exposure conditions without restriction.
Contact Information
For qualified repair specialists requesting repair information and parts, please contact the original manufacturer at customersupport@gemsfindyours.com
Distributed by Chug, Inc.
7157 Shady Oak RD, Eden Prairie, MN 55344