Whirlpool Electric and Gas Dryer Dimension Guide
This guide provides detailed planning dimensions and installation spacing requirements for Whirlpool electric and gas dryers, specifically models WED4900LW and WGD4900LW.
Product Overview
The document illustrates two dryer models: WED4900LW (Electric) and WGD4900LW (Gas). It includes comprehensive measurements for installation planning.
Electrical Requirements
Fuel Type | Electric | Gas |
---|---|---|
Minimum Circuit Amperage Rating | 30 A | 15 A |
Maximum AMP Draw | 26 A | 6 A |
Operating Voltage | 120/240 V - AC only | 120 V - AC only |
Current Canada Rating | 24 A | - |
Operating Frequency | 60 Hz | 60 Hz |
Product Dimensions
The following tables detail the dimensions of the dryers in inches (in) and millimeters (mm).
Front and Side Views
Label | Description | in | mm |
---|---|---|---|
A | Height (with leveling legs not extended) | 40 1/2 | 1028 |
B | Width | 29 | 737 |
C | Top Height (with min. feet) | 36 7/8 | 937 |
D | Depth | 28 3/8 | 722 |
E | Top Height (with leveling legs fully extended) | 38 1/2 | 978 |
F | Height (with leveling legs fully extended) | 42 1/8 | 1069 |
G | Depth with Door Open | 41 11/16 | 1059 |
Rear Views and Specific Connections
Label | Description | in | mm |
---|---|---|---|
H | Strain Relief from Side (electric) | 15 3/4 | 400 |
I | Strain Relief Height (electric) (with leveling legs not extended) | 28 1/8 | 714 |
J | Exhaust Duct from Side | 14 7/16 | 366 |
K | Power Cord from Side (gas) | 14 3/4 | 375 |
L | Power Cord Height (gas) | 32 3/8 | 822 |
M | Gas Connection (with leveling legs not extended) | 1 11/16 | 43 |
N | Gas Connection from Side | 9 3/16 | 234 |
O | Strain Relief Height (electric) (with leveling legs fully extended) | 29 3/4 | 755 |
P | Exhaust Duct Height (with leveling legs fully extended) | 6 11/16 | 170 |
Q | Power Cord Height (gas) | 34 | 863 |
R | Gas Connection (with leveling legs fully extended) | 3 5/16 | 84 |
S | Exhaust Duct Height (with leveling legs not extended) | 5 1/16 | 128 |
- | Gas Power Cord Length | 60 | 1525 |
Spacing for Recessed Area or Closet Installation
The following dimensions are for recommended spacing. Additional spacing may be needed for installation, servicing, wall/door moldings, and floor trim.
- An additional 1" (25 mm) spacing on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation with a door, minimum air ventilation openings are required at the top and bottom of the door. Louvered doors with equivalent openings are acceptable.
- Consider spacing for adjacent appliances.
14" max (356 mm) top clearance;
6"/0" (152 mm/0 mm) side clearance;
1"/0" (25 mm/0 mm) front clearance.
18" (460 mm) depth clearance.
3" (76 mm) top vent opening (48 in²/310 cm²);
3" (76 mm) bottom vent opening (24 in²/155 cm²);
1" (25 mm) side vent opening.
Important Safety Information
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.