Whirlpool Dryer Dimension Guide
Models: WED5010LW, WED500RMW (Electric) / WGD5010LW, WGD500RLW (Gas)
Electrical Requirements
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.
| Fuel Type | Electric | Gas |
|---|---|---|
| Minimum Circuit Amperage Rating | 30 A | 15 A |
| Maximum AMP Draw | 26 A | 6 A |
| Operating Voltage | 120/240 V - AC only | 120 V - AC only |
| Current Canada Rating | 24 A | |
| Operating Frequency | 60 Hz | 60 Hz |
Product Dimensions
Diagrams show front, side, and top views of the dryer with dimensions labeled A through G.
| Label | Description | Inches (in) | Millimeters (mm) |
|---|---|---|---|
| A | Height (With leveling legs not extended) | 401⁄2 | 1028 |
| B | Width | 29 | 737 |
| C | Top Height (with min. feet) | 367⁄8 | 937 |
| D | Depth | 283⁄8 | 722 |
| E | Top Height (With leveling legs fully extended) | 381⁄2 | 978 |
| F | Height (With leveling legs fully extended) | 421⁄8 | 1069 |
| G | Depth with Door Open | 4111⁄16 | 1059 |
Detailed Product Dimensions (Connections & Clearances)
Diagrams show rear and side views of the dryer, indicating dimensions labeled H through S for electrical connections, exhaust ducts, and gas connections.
| Label | Description (Electric) | Description (Gas) | Inches (in) | Millimeters (mm) |
|---|---|---|---|---|
| H | Strain Relief from Side | 15 3⁄4 | 400 | |
| I | Strain Relief Height (With leveling legs not extended) | 28 1⁄8 | 714 | |
| J | Exhaust Duct from Side | 14 7⁄16 | 366 | |
| K | Power Cord from Side | 14 3⁄4 | 375 | |
| L | Power Cord Height | 32 3⁄8 | 822 | |
| M | Gas Connection (With leveling legs not extended) | 1 11⁄16 | 43 | |
| N | Gas Connection from Side | 9 3⁄16 | 234 | |
| O | Strain Relief Height (With leveling legs fully extended) | 29 3⁄4 | 755 | |
| P | Exhaust Duct Height (With leveling legs fully extended) | 6 11⁄16 | 170 | |
| Q | Power Cord Height | 34 | 863 | |
| R | Gas Connection (With leveling legs fully extended) | 3 5⁄16 | 84 | |
| S | Exhaust Duct Height (With leveling legs not extended) | 5 1⁄16 | 128 | |
| Gas Power Cord Length | 60 | 1525 |
Spacing for Recessed Area or Closet Installation
The dimensions shown are for the recommended spacing allowed. Additional spacing should be considered for ease of installation and servicing. Additional clearances might be required for wall, door, and floor moldings. An additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer. For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable. Companion appliance spacing should also be considered.
The diagram illustrates recommended clearances:
- Maximum depth clearance: 14 inches (356 mm)
- Top clearance: 18 inches (460 mm)
- Side clearance: 3 inches (76 mm)
- Minimum ventilation openings: 48 square inches (310 cm²) at the top, 24 square inches (155 cm²) at the bottom.
- Recommended additional spacing for noise reduction: 1 inch (25 mm) on all sides.
