This guide provides detailed planning dimensions for Whirlpool electric and gas dryers, including models YWED5010LW, WED5050LW, YWED5050LW (Electric), and WGD5050LW (Gas).
WARNING: To reduce the risk of fire, electric shock, or injury to persons, read the IMPORTANT SAFETY INSTRUCTIONS and INSTALLATION INSTRUCTIONS, located in your appliance's Owner's Manual, before installing and operating this appliance.
General Dryer Dimensions
The following dimensions apply to both electric and gas dryer models, illustrating their overall size for planning purposes.
Whirlpool Electric Dryer (YWED5010LW, WED5050LW, YWED5050LW)
Illustration of a Whirlpool electric dryer with approximate overall dimensions: Height 40½", Depth 28⅜", Width 29".
Whirlpool Gas Dryer (WGD5050LW)
Illustration of a Whirlpool gas dryer with approximate overall dimensions: Height 40½", Depth 28⅜", Width 29".
Dimension | in | mm |
---|---|---|
Height (With leveling legs not extended) | 40½ | 1028 |
Width | 29 | 737 |
Top Height (with min. feet) | 36⅞ | 937 |
Depth | 28⅜ | 722 |
Top Height (With leveling legs fully extended) | 38½ | 978 |
Height (With leveling legs fully extended) | 42⅛ | 1069 |
Depth with Door Open | 50¹¹⁄₁₆ | 1288 |
Electrical Requirements
This table outlines the electrical specifications for both electric and gas dryer models.
Fuel Type | Electric | Gas |
---|---|---|
Minimum Circuit Amperage Rating | 30 A | 15 A |
Maximum AMP Draw | 26 A | 6 A |
Operating Voltage | 120/240 V - AC only | 120 V - AC only |
Current Canada Rating | 24 A | N/A |
Operating Frequency | 60 Hz | 60 Hz |
Detailed Planning Dimensions (Side and Rear Views)
The following tables provide specific measurements for various connection points and components from the side and rear of the dryer, crucial for installation planning. Diagrams illustrate these points, labeled H through T.
Electric Dryer Detailed Dimensions
Side and rear views of the electric dryer illustrating various connection points and component heights/distances.
Gas Dryer Detailed Dimensions
Side and rear views of the gas dryer illustrating various connection points and component heights/distances.
Dimension | in | mm |
---|---|---|
Strain Relief from Side (electric) | 15¾ | 400 |
Strain Relief Height (electric) (With leveling legs not extended) | 28⅛ | 714 |
Exhaust Duct from Side | 14⁷⁄₁₆ | 366 |
Power Cord from Side (gas) | 14¾ | 375 |
Power Cord Height (gas) | 32⅜ | 822 |
Gas Connection (With leveling legs not extended) | 1¹¹⁄₁₆ | 43 |
Gas Connection from Side | 9³⁄₁₆ | 234 |
Strain Relief Height (electric) (With leveling legs fully extended) | 29¾ | 755 |
Exhaust Duct Height (With leveling legs fully extended) | 6¹¹⁄₁₆ | 170 |
Gas Connection (With leveling legs fully extended) | 3⁵⁄₁₆ | 84 |
Exhaust Duct Height (With leveling legs not extended) | 5¹⁄₁₆ | 128 |
Water Inlet Height (on steam models only) | 32⅛ | 816 |
Water Inlet from Side (on steam models only) | 4 | 101 |
Gas Power Cord Length | 60 | 1525 |
Power Cord Length (Canadian) | 52⅜ | 1330 |
Spacing for Recessed Area or Closet Installation
The dimensions shown are for the recommended spacing allowed for dryer installation in recessed areas or closets.
- Additional spacing should be considered for ease of installation and servicing.
- Additional clearances might be required for wall, door, and floor moldings.
- Additional spacing of 1" (25 mm) on all sides of the dryer is recommended to reduce noise transfer.
- For closet installation with a door, minimum ventilation openings in the top and bottom of the door are required. Louvered doors with equivalent ventilation openings are acceptable.
- Companion appliance spacing should also be considered.
Diagram illustrating recommended clearances for recessed area or closet installation, showing minimum spacing requirements:
- Overhead clearance: 14" max (356 mm)
- Depth from rear wall: 18" (460 mm)
- Top clearance: 3" (76 mm)
- Side clearance: 1" (25 mm)
- Rear clearance: 6"/0" (152 mm/0 mm)
- Front clearance: 1"/0" (25 mm/0 mm)
- Minimum ventilation openings for closet with door: 48 in² (310 cm²) at top, 24 in² (155 cm²) at bottom.