1. Door Prep
Diagram illustrating door preparation. Requires two bores: a 1-inch diameter bore on the door edge and a 2-1/8 inch diameter bore on the door face. The distance between the centers of these bores should be 2-3/8 inches or 2-3/4 inches. The bores are positioned 2-1/4 inches from the top and bottom of the door edge. The depth for the edge bore is 1/8 inch. The face bore depth is not less than 4-1/2 inches.
2. Door Jamb Prep
Diagram showing door jamb preparation for the strike plate. The strike plate recess is 3/16 inch deep. The strike plate dimensions are approximately 2-3/4 inches in height and 1-1/8 inches in width. A 1/8 inch bore depth is also indicated.
3. Install Outside Trim
Illustration of the outside trim assembly. Features the lock cylinder with a horizontal tailpiece. An optional extension collar for thin doors is shown. Note: 'Plates and grip vary depending on style.'
4. Install Inside Trim
Illustration of the inside trim assembly. Includes the interior trim piece and mounting screws. An Allen wrench is shown for tightening a set screw, with the instruction: 'After lock has been installed tighten set screw with Allen Wrench'. An optional extension collar for thin doors is also depicted.
Document Revision: IN4-ENTSETDLSEC REV. 21A 10/8/21
