Bed Frame Instruction Manual
Models: BF-WT01-Q, BF-WT01-F
1. Component List
[Left bed leg]
A x1
[Right bed leg]
B x1
[Left bed tail leg]
C x1
[Right bed tail leg]
D x1
[Head and tail board]
E x4
[Head and tail rail]
F x4
[link bar]
G x3
[Ribs strip]
H x10
[Side frame]
I x2
[Middle frame]
J x1
2. Hardware
[M8x50mm screw]
1 x4pcs
[M6x55mm screw]
2 x16pcs
[M6x25mm screw]
3 x4pcs
[M6x20mm screw]
4 x12pcs
[Washer]
5 x8pcs
[Bolt]
6 x4pcs
[Nut]
7 x16pcs
[Allen wrench]
8 x2pcs
[M6x30mm screw]
9 x6pcs
[Anti-friction strip]
10 x1pc
Assembly Steps
Step 1
Attach head and tail rails (F) to the bed legs (A, B, C, D) using nuts (7) and allen wrench (8).
For easy setup, do not tighten screws during the installation process.
Step 2
Attach head and tail boards (E) to the assembled frame using screws (4) and allen wrench (8).
Step 3
Assemble the side frames (I) by unfolding them.
Step 4
Attach the assembled side frames (I) to the bed frame using screws (1), washers (5), bolts (6), and nuts (3). Use allen wrench (8).
Step 5
Insert link bars (G) into the designated slots and secure them with screws (9) and allen wrench (8).
Step 6
Assemble the middle frame (J) by unfolding it.
Step 7
Attach the middle frame (J) to the bed frame. To prevent friction noise, unroll the anti-friction strip (10) and fit it onto the middle frame (J). Secure with screws (2) and nuts (7).
Step 1: Tighten screw 2.
Step 8
Place the ribs strips (H) across the side frames (I) and middle frame (J) to support the mattress.
NOTE: Tighten all screws.
