Westfalia LED Plant Grow Light 80W

Introduction

Instruction manuals provide valuable hints for using your new device. They enable you to use all functions and help you avoid misunderstandings and prevent damage. Please take the time to read this manual carefully and keep it for future reference.

Safety Notes

⚠ Please note the following safety notes to avoid malfunctions, damage, or physical injury:

• Please read this manual carefully and use the device only according to this manual.
• Dispose of used packaging material carefully or store it out of the reach of children. There is a danger of suffocation!
• Persons with limited physical, sensorial, or mental abilities are not allowed to use the device, unless they are supervised and briefed for their safety by a qualified person.
• The lamps are not toys. Do not allow children to play with them.
• The product must not be exposed to extreme temperatures, strong vibrations, or strong mechanical stress.
• Do not stare directly into the LEDs and do not direct the light beam towards people or animals. Do not use devices that can strongly focus light for viewing the light beam.
• Should the unit become damaged, do not use it any further and have it repaired by a professional or contact customer service. Do not disassemble the unit or try repairing it yourself.

Light Spectrum

The graph displays the spectral output of the LED plant grow light. The x-axis represents wavelength in nanometers (nm), ranging from 350 to 850 nm. The y-axis represents light intensity, with a peak value of 1.0 corresponding to 1.947e+002 mW/nm. The spectrum shows significant peaks in the blue light region (around 460-470 nm) and the red light region (around 620-630 nm), which are crucial for plant photosynthesis. It also shows output across the green, yellow, and orange parts of the visible spectrum, as well as UV and IR wavelengths, indicating a full-spectrum light source.

Operation

Intended Use

The LED plant grow light is intended to support the growth of plants. It is not suitable for general illumination.

Assembly and Setup

Hang the LED Plant Grow Light in a suitable position. Ensure the light reaches the plants from directly above to promote even growth and prevent them from leaning to one side.

Connect the power plug to a suitable wall socket.

Use the on/off switch located on the back of the lamp to turn the unit on and off.

Cleaning

Wipe the housing of the device with a lightly moistened cloth. Detergent may be used as needed. Do not immerse the device in water or any other liquid.

Avoid using aggressive chemicals or abrasive cleaners to prevent damage to the surfaces.

Technical Data

EU Declaration of Conformity

Westfalia Werkzeugcompany, Werkzeugstraße 1, D-58093 Hagen, declares by its own responsibility that the product LED Plant Grow Light 80 W (Article No. 95 14 07) meets the essential safety requirements, which are defined in the European Directives and their amendments.

• 2011/65/EU: Restriction of the Use of certain hazardous Substances in electrical and electronic Equipment (RoHS)
• 2014/30/EU: Electromagnetic Compatibility (EMC) - EN 55015:2019+A11, EN 61547:2009, EN 61000-3-2:2014, EN 61000-3-3:2013
• 2014/35/EU: Low Voltage Directive (LVD) - EN 60598-1:2015+AC+A1, EN 60598-2-1:1989, EN 62493:2010

The technical documentations are on file at the QA department of the Westfalia Werkzeugcompany.

Signed: Thomas Klingbeil, Quality Representative. Dated: Hagen, November 12, 2021.

Customer Service & Disposal

Customer Service

Contact information for Westfalia is provided for Germany, Switzerland, and Austria.

Disposal

Dear Customer, please help avoid waste materials. If you intend to dispose of this article, please keep in mind that many of its components consist of valuable materials, which can be recycled. Please do not discharge it in the rubbish bin, but check with your local council for recycling facilities in your area.