MALM
Design and Quality by IKEA of Sweden
Important Safety Information
This furniture must be fixed to the wall with the enclosed wall fastener. Different wall materials require different types of fixing devices. Use fixing devices suitable for the walls in your home (not included). If you are uncertain about what type of screw or fitting to use, please contact your hardware store.
Tools and Preparation
The following tools are recommended for assembly:
- Screwdriver ?
- Hammer ?
- Spirit Level ?
- Tape Measure ?
Assembly Guidance:
- Diagram shows correct handling of furniture parts during assembly. ❌ indicates incorrect handling.
- If you are unsure about assembly, seek advice. ❓ indicates uncertainty, and a person is shown contacting IKEA ? ? IKEA.
Parts Included
Please check that you have all the parts listed below:
- Screw (Part #114334) - 3x
- Screw (Part #109548) - 10x
- Dowel (Part #101359) - 4x
- Bracket (Part #113456) - 3x
- Fitting/Nut (Part #114254) - 3x
- Component (Part #102372) - 3x
- Circular Component (Part #117020) - 2x
- Cylindrical Component (Part #106433) - 2x
- Wrench (Part #113453) - 1x
Assembly Steps
-
Step 1: Attach a panel using three screws (Part #113453) and the wrench (Part #113453).
-
Step 2: Insert four dowels (Part #101359) into the pre-drilled holes of a panel.
-
Step 3: Attach three brackets (Part #113456) to a panel using screws (Part #114254) and the wrench (Part #113453).
-
Step 4: Attach three components (Part #102372) to a panel.
-
Step 5: Attach two circular components (Part #117020) and two cylindrical components (Part #106433) to a panel using screws (Part #109548).
-
Step 6: Mark the wall for mounting points. Use a spirit level and tape measure to ensure correct placement. The marks should be 89 mm (3 1/2 inches) from the top edge.
-
Step 7: Insert two screws (Part #109548) into the wall at the marked points. Ensure they protrude about 7 mm (4/16 inch).
-
Step 8: Carefully hang the assembled unit onto the screws in the wall.
