iDimension Plus Upgrade Kit Installation Instructions
These instructions detail the installation of the upgrade kit for the iDimension Plus, updating it to the latest version.
Manuals are available from Rice Lake Weighing Systems at www.ricelake.com/manuals.
Warranty information is available at www.ricelake.com/warranties.
Figure 1. iDimension Plus Upgrade Kit Parts
The upgrade kit includes the following components:
| Item No. | Part No. | Description | Qty. |
|---|---|---|---|
| 1 | 150660 | Mounting screw, M4-0.7x20 cap | 3 |
| 2 | 223603 | Main unit iDimension Plus 2.0 | 1 |
| 3 | 223778 | Plate, iDim 2.0 black, rear | 1 |
| 4 | 65680 | Screws, KEPS 6-32 external | 6 |
| 5 | 222730 | Adapter, DC power | 1 |
| - | 206585 | Calibration object iDim Plus 2.0 | 1 |
| - | 227300 | Screw kit, iDimension Plus 2.0 | 1 |
Table 1. List of iDimension Plus upgrade kit parts (Part No. 228864)
NOTE: For more detailed instructions on mounting procedures for the iDimension Plus, consult the iDimension Plus mounting instructions (Part No. 197164).
1.0 Removing the Existing Head
- Remove the rear screws and the rear plate of the old scan head using a Phillips screwdriver.
(See Figure 2 and Figure 3 for screw positions) - Disconnect the cable connections and the power adapter.
(See Figure 4 for disconnected connections) - Locate the keyholes on the top of the iDimension post.
- Loosen the mounting screws without removing them, using a hex wrench from the screw kit.
(See Figure 5 for keyhole locations) - Lift to remove the old scan head from the post assembly.
IMPORTANT: Carefully feed the cables through the cable slot when removing the scan head to avoid damage. - Replace the rear screws and the rear plate of the scan head.
- Dispose of the scan head.
2.0 Reassembling the Unit
- Thread the mounting screws into the new scan head. Do not tighten them yet.
(See Figure 6 for threaded mounting screws) - Remove the rear screws and the rear plate of the scan head.
(See Figure 7 for new rear screw positions) - Carefully feed the cables through the cable slot.
- Align, insert, and lower the mounting screw heads into the keyholes of the post assembly.
- Tighten the mounting screws.
- Attach the adapter to the power cable.
(See Figure 8 for adapted power cable assembly) - Connect the cable connections and the power adapter.
(See Figure 9 for connected cables and power adapter) - Reattach the rear plate and rear screws.
