DRIJA Diamond 90

Safety Warnings

1. Safety Warnings

• Never let children operate the machine.
• The range hood is for domestic use only; not recommended for barbecues, rotisseries, or any other commercial purpose.
• The cooker hood and its filter should be cleaned regularly to keep it working in good condition.
• Clean the cooker hood according to the instructions in the manual and keep the unit out of danger of burns.
• Prohibit direct cooking from the gas cooker.
• Please keep the kitchen with good convection.
• Before connecting the appliance, check that the power cord is not damaged. Damaged power cords must be replaced by suitable personnel.
• Adequate ventilation in the kitchen should be provided when using the cooker hood along with other gas appliances or other fuels.
• The air should not be thrown by a pipe that is used to evacuate fumes from gas appliances or other fuels.
• The regulations concerning the evacuation of air must be taken into account.
• Do not place a flame of fire under the hood.
• The cooker hood should not be installed on stoves having more than 4 burners.
• This appliance may not be used by persons (including children) with physical, mental, or little or no disability unless instructed to use and supervise the person taking care of their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• When the hood and appliances supplied with power other than the electric one are running at the same time, the negative pressure in the room should not exceed 4 Pa (4 x 10-5 bar).
• Caution: Accessible parts may become hot during use of the appliance.

2. Electric Shock Hazard

• Only connect this unit to an appropriate ground. If in doubt, consult a qualified engineer.
• Failure to follow these instructions can result in death, fire, or electric shock.

Installation

3. Installation

The hood can be installed as an extractor or recirculation hood.

The range hood should be placed at a minimum installation distance from the stove of 30" (75 cm) from the cooking surface to obtain the best effect.

Installation steps:

• Install the hook on a suitable place once the installation height is fixed, and keep it in line.
• Fix the outside chimney; its height can be adjusted freely. (See diagram for reference).
• Hang the range hood onto the hood plate and fix the chimney with 4 screws.
• Put on the external chimney and fix it with the chimney holder. (See diagram for reference).
• Finally, fix the external chimney to the wall. (See diagram for reference).
• Adjust the height of the inner chimney to the desired positions by slightly widening the outer chimney and screwing it in place. (See diagram for reference).

The extractor uses 2 lights of 1.5W each.

IMPORTANT: The equipment must have a voltage protector.

Controls and Operation

Electronic Button / LED Touch Control Panel

The touch control panel features ON/OFF, speed adjustment (+/-), and lighting controls.

Power ON/OFF: Press the ON/OFF button. The buzzer will sound five times, indicating the appliance is powered on. The screen displays '8'.

Light Control: Touch the "light" button for 0.5 seconds to turn the lights on or off.

Speed Control:

• Touch the ON/OFF button for 0.5 seconds to turn on the motor at speed 1 (display shows '1').
• Touch the "+" button to increase speed to 2 (middle speed).
• Touch the "+" button again to reach speed 3 (highest speed).

Reduce Speed:

• Touch the "-" button to decrease speed to 2 (second speed).
• Touch the "-" button again to decrease speed to 1 (low speed).

Delay Off Function: Simultaneously press the "+" and "-" buttons. The range hood will turn off automatically after 5 minutes. The display will flash. Press the ON/OFF button to stop the delay function and turn off the hood immediately.

Installation Notice

Notice of Installation

Before installation, ensure the area is clean to avoid suction of broken wood and dust.

The ventilation tube cannot be shared with other appliances (e.g., gas, warmer, hot wind tubes).

The ventilation tube bending should be at least 120°, be parallel or above the start point, and connect to the external wall.

After installation, ensure the extractor is level to prevent grease collection at one end.

Maintenance and Cleaning

4. Maintenance and Cleaning

1. Cleaning of the Carbon Grease Filter Mesh

The filter mesh is made of high-density stainless steel. Do not use corrosive detergent. Keeping it clean ensures correct operation.

Aluminum filters should be cleaned every 15 days with neutral soap.

Method 1: Soak the mesh in 40-50°C clean water with detergent for 2-3 minutes. Clean with a soft brush. Avoid excessive pressure as the mesh is delicate.

Method 2: The mesh can be cleaned in a dishwasher at approximately 60°C.

2. Cleaning the Cooker Hood Body

To protect the main body from corrosion, clean it every two months with hot water and a non-corrosive detergent.

Recommended cleaner: WD-40.

Do not use abrasive detergent, as it can damage the body.

Keep the motor and other spare parts dry to prevent damage.

Always cut off power before cleaning.

Do not tear open the fixed bar around the carbon filter.

If the plug or cord is damaged, replace it with a special soft cord.

Troubleshooting

Troubleshooting Guide

Warranty Information

Warranty Exclusions

• Filter mesh or light bulb.
• Commercial use.
• Modification of the date of manufacture on the plate.
• After 24 months from purchase data.
• Damage to glass parts, S / S, or LED parts.
• Improper installation, misuse, abuse or neglect.
• Incorrectly connected to insufficient or inadequate power source.
• Damage caused by foreign objects.
• Un-installation by unauthorized technicians, use of spare parts from other manufacturers.

For commercial use, maintenance and free service must be discussed with an authorized agent.

After the 24-month warranty period, the buyer must pay for service and spare parts.

To request service, please provide the warranty certificate and purchase invoice.

Shop place: _________________________

Date of purchase: _________________________

Model: _________________________

Warehouse stamp: _________________________

Disposal Information

ELIMINATION: No Remove this product As municipality Waste.

Collection of Separate waste

For special treatment is necessary.

This Grease Extractor is labeled in accordance with the European Directive 2012/19 / EU for Waste Electrical and Electronic Equipment (WEEE). Proper disposal helps prevent harm to the environment and human health.

The symbol on the product indicates it cannot be treated as normal residue. It should be taken to a collection point for the recycling of electrical and electronic products.

This grease extractor is special waste disposal. For more information about treatment, recovery, and recycling, contact your local council, household waste disposal service, or the store where you purchased it.

[WEEE symbol] (Crossed-out wheelie bin symbol)